NETGEAR FVS318N IPv6 DMZ WAN Outbound Service Rules,  To create a new IPv6 DMZ WAN outbound rule

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

2.Enter the settings as explained in Table 33 on page 131. In addition to selections from the Service, Action, and Log drop-down lists, you need to make selections from the following drop-down lists:

•DMZ Users

•WAN Users

Unless your selection from the Action drop-down list is BLOCK always, you also need to make selections from the following drop-down lists:

•Select Schedule

•QoS Priority

•NAT IP (This drop-down list is available only when the WAN mode is NAT. If you select Single Address, the IP address specified should fall under the WAN subnet.)

3.Click Apply. The new rule is now added to the Outbound Services table. The rule is automatically enabled.

IPv6 DMZ WAN Outbound Service Rules

To create a new IPv6 DMZ WAN outbound rule:

1.In the upper right of the DMZ WAN Rules screen, select the IPv6 radio button. The screen displays the IPv6 settings (see Figure 70 on page 147).

2.Click the Add table button under the Outbound Services table. The Add DMZ WAN Outbound Service screen for IPv6 displays:

Figure 72.

Firewall Protection

149