NETGEAR FVS318N manual IPSec VPN Wizard settings for a client-to-gateway tunnel, 205

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

2.Complete the settings as explained in the following table:

Table 44. IPSec VPN Wizard settings for a client-to-gateway tunnel

Setting	Description
About VPN Wizard
This VPN tunnel will connect	Select the VPN Client radio button. The default remote FQDN (remote.com)
to the following peers	and the default local FQDN (local.com) display in the End Point Information
	section of the screen.
Connection Name and Remote IP Type
What is the new Connection	Enter a descriptive name for the connection. This name is used to help you to
Name?	manage the VPN settings; the name is not supplied to the VPN client.
What is the pre-shared key?	Enter a pre-shared key. The key needs to be entered both here and on the
	remote VPN gateway, or the remote VPN client. This key needs to have a
	minimum length of 8 characters and cannot exceed 49 characters.
End Point Informationa
What is the Remote	When you select the Client radio button in the About VPN Wizard section of
Identifier Information?	the screen, the default remote FQDN (remote.com) is automatically entered.
	Use the default remote FQDN, or enter another FQDN.
	Note: The remote ID on the wireless VPN firewall is the local ID on the VPN
	client. It might be less confusing to configure an FQDN such as client.com as
	the remote ID on the wireless VPN firewall and then enter client.com as the
	local ID on the VPN client.
What is the Local Identifier	When you select the Client radio button in the About VPN Wizard section of
Information?	the screen, the default local FQDN (local.com) is automatically entered. Use
	the default local FQDN, or enter another FQDN.
	Note: The local ID on the wireless VPN firewall is the remote ID on the VPN
	client. It might be less confusing to configure an FQDN such as router.com
	as the local ID on the wireless VPN firewall and then enter router.com as the
	remote ID on the VPN client.
Secure Connection Remote Accessibility
What is the remote LAN IP
Address?	These fields are masked out for VPN client connections.
What is the remote LAN
Subnet Mask?

a. Both local and remote endpoints should be defined as either FQDNs or IP addresses. A combination of an IP address and an FQDN is not supported.

3.Click Apply to save your settings. The IPSec VPN policy is now added to the List of VPN Policies table on the VPN Policies screen for IPv4. By default, the VPN policy is enabled.

Virtual Private Networking Using IPSec and L2TP Connections

205