NETGEAR FVS318N manual Test the Mode Config Connection, 258

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

2.Specify the following default lifetimes in seconds to match the configuration on the wireless VPN firewall:

• Authentication (IKE), Default. Enter 3600 seconds.

Note: The default setting is 28800 seconds (8 hours). However, for a Mode Config configuration, NETGEAR recommends 3600 seconds (1 hour).

•Encryption (IPSec), Default. Enter 3600 seconds.

3.Select the Dead Peer Detection (DPD) check box, and configure the following DPD settings to match the configuration on the wireless VPN firewall:

•Check Interval. Enter 30 seconds.

•Max. number of entries. Enter 3 retries.

•Delay between entries. Leave the default delay setting of 15 seconds.

4.Click Apply to use the new settings immediately, and click Save to keep the settings for future use.

The Mode Config configuration of the VPN client is now complete.

Test the Mode Config Connection

To test the Mode Config connection from the VPN client to the wireless VPN firewall: 1. Right-click the system tray icon, and select Open tunnel ‘Tunnel_ModeConfig’.

Figure 154.

When the tunnel opens successfully, the Tunnel opened message displays above the system tray, and the VPN client displays a green icon in the system tray.

Figure 155.

Virtual Private Networking Using IPSec and L2TP Connections

258