NETGEAR FVS318N manual Configure DMZ WAN Rules, 145

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

Figure 68.

3.Enter the settings as explained in Table 34 on page 135. In addition to selections from the Service, Action, and Log drop-down lists, you need to make selections from the following drop-down lists:

•LAN Users

•WAN Users

Unless your selection from the Action drop-down list is BLOCK always, you also need to make a selection from the following drop-down list:

• Select Schedule

4.Click Apply to save your changes. The new rule is now added to the Inbound Services table.

Configure DMZ WAN Rules

•Create DMZ WAN Outbound Service Rules

•Create DMZ WAN Inbound Service Rules

The firewall rules for traffic between the DMZ and the Internet are configured on the DMZ WAN Rules screen. The default outbound policy is to block all traffic from and to the Internet. You can then apply firewall rules to allow specific types of traffic either going out from the DMZ to the Internet (outbound) or coming in from the Internet to the DMZ (inbound).

There is no drop-down list that lets you set the default outbound policy as there is on the LAN WAN Rules screen. You can change the default outbound policy by enabling all outbound traffic and then blocking only specific services from passing through the wireless VPN firewall. You do so by adding outbound services rules (see Create DMZ WAN Outbound Service Rules on page 148).

Firewall Protection

145