NETGEAR FVS318N Create DMZ WAN Inbound Service Rules, IPv4 DMZ WAN Inbound Service Rules, 150

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

3.Enter the settings as explained in Table 33 on page 131. In addition to selections from the Service, Action, and Log drop-down lists, you need to make selections from the following drop-down lists:

•DMZ Users

•WAN Users

Unless your selection from the Action drop-down list is BLOCK always, you also need to make selections from the following drop-down lists:

•Select Schedule

•QoS Priority

4.Click Apply. The new rule is now added to the Outbound Services table. The rule is automatically enabled.

Create DMZ WAN Inbound Service Rules

The Inbound Services table lists all existing rules for inbound traffic. If you have not defined any rules, no rules are listed. By default, all inbound traffic (from the Internet to the DMZ) is blocked.

Inbound rules that are configured on the LAN WAN Rules screen take precedence over inbound rules that are configured on the DMZ WAN Rules screen. As a result, if an inbound packet matches an inbound rule on the LAN WAN Rules screen, it is not matched against the inbound rules on the DMZ WAN Rules screen.

IPv4 DMZ WAN Inbound Service Rules

To create a new IPv4 DMZ WAN inbound rule:

1.In the upper right of the DMZ WAN Rules screen, the IPv4 radio button is selected by default. The screen displays the IPv4 settings (see Figure 69 on page 146).

Click the Add table button under the Inbound Services table. The Add DMZ WAN Inbound Service screen for IPv4 displays:

Firewall Protection

150