NETGEAR FVS318N manual Configure Advanced WAN Options and Other Tasks,  To configure Siit

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

For SIIT to function, the routing mode needs to be IPv4 / IPv6. NETGEAR’s implementation of SIIT lets you enter a single IPv4 address on the SIIT screen. This IPv4 address is then used in the IPv4-translated address for IPv6 devices to enable communication between IPv4-only devices on the wireless VPN firewall’s LAN and IPv6-only devices on the WAN.

To configure SIIT:

1. Select Network Configuration > SIIT. The SIIT screen displays:

Figure 28.

2.Select the Enable SIIT check box.

3.In the SIIT Address fields, enter the IPv4 address that should be used in the IPv4-translated address for IPv6 devices.

4.Click Apply to save your changes.

Configure Advanced WAN Options and Other Tasks

The advanced options include configuring the maximum transmission unit (MTU) size, port speed, and wireless VPN firewall’s MAC address, and setting a rate limit on the traffic that is being forwarded by the wireless VPN firewall.

Note: Although you can access the Broadband Advanced Options screen only through the Broadband ISP Settings (IPv4) screen, the advanced options apply to both IPv4 and IPv6 WAN connections.

To configure advanced WAN options:

1.Select Network Configuration > WAN Settings > Broadband ISP Settings. The Broadband ISP Settings screen displays the IPv4 settings (see Figure 10 on page 29).

2.Click the Advanced option arrow in the upper right of the screen. The Broadband Advanced Options screen displays:

IPv4 and IPv6 Internet and Broadband Settings

50