NETGEAR FVS318N manual Configure Keep-Alives, 260

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

establishment time. If you require a VPN tunnel to remain connected, you can use the keep-alive and Dead Peer Detection (DPD) features to prevent the tunnel from being disconnected and to force a reconnection if the tunnel disconnects for any reason.

For DPD to function, the peer VPN device on the other end of the tunnel also needs to support DPD. Keep-alive, though less reliable than DPD, does not require any support from the peer device.

Configure Keep-Alives

The keep-alive feature maintains the IPSec SA by sending periodic ping requests to a host across the tunnel and monitoring the replies.

To configure the keep-alive feature on a configured VPN policy:

1.Select VPN > IPSec VPN > VPN Policies. The VPN Policies screen displays the IPv4 settings (see Figure 141 on page 231).

2.Specify the IP version for which you want to edit a VPN policy:

•IPv4. In the upper right of the screen, the IPv4 radio button is already selected by default. Go to Step 3.

•IPv6. Select the IPv6 radio button. The VPN Policies screen for IPv6 displays.

3.In the List of VPN Policies table, click the Edit table button to the right of the VPN policy that you want to edit. The Edit VPN Policy screen displays. (The following figure shows only the top part with the General section of the Edit VPN Policy screen for IPv6.)

Figure 157.

Virtual Private Networking Using IPSec and L2TP Connections

260