NETGEAR FVS318N manual Manage Static IPv4 Routing, Configure Static IPv4 Routes

ProSafe Wireless-N 8-Port Gigabit VPN Firewall FVS318N

To delete one or more advertisement prefixes:

1.On the RADVD screen for the DMZ screen (see Figure 47 on page 95), select the check box to the left of each advertisement prefix that you want to delete, or click the Select All table button to select all advertisement prefixes.

2.Click the Delete table button.

Manage Static IPv4 Routing

•Configure Static IPv4 Routes

•Configure the Routing Information Protocol

•IPv4 Static Route Example

Static routes provide additional routing information to your wireless VPN firewall. Under normal circumstances, the wireless VPN firewall has adequate routing information after it has been configured for Internet access, and you do not need to configure additional static routes. You should configure static routes only for unusual cases such as multiple firewalls or multiple IP subnets located on your network.

Note: The wireless VPN firewall automatically sets up routes between VLANs and secondary IPv4 addresses that you have configured on the LAN Multi-homing (IPv4) screen (see Configure IPv4 Multihome

LAN IP Addresses on the Default VLAN on page 65). Therefore, you

do not need to manually add an IPv4 static route between a VLAN and a secondary IPv4 address.

Configure Static IPv4 Routes

To add an IPv4 static route to the Static Route table:

1.Select Network Configuration > Routing. In the upper right of the screen, the IPv4 radio button is selected by default. The Static Routing screen displays the IPv4 settings. (The following figure contains one example.)

Figure 49.

LAN Configuration

98