Weber 3000 LX Annual Maintenance, Inspection and Cleaning of the Weber Spider Stopper Guards

Page 25

Annual Maintenance

After a period of nonuse we recommend that you perform the following maintenance procedures for your safety.

mWARNING: Check hose before each use of barbecue for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the barbecue. Replace using only Weber authorized replacement hose. Order from Weber-Stephen Products Co., Customer Service Center or authorized dealer.

Inspect the burners for correct flame pattern. Clean if necessary, following the procedures outlined in the "General Maintenance" section of this manual.

Check all gas fittings for leaks.

mDANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. This will result in a fire or explosion which can cause serious bodily injury or death, and damage to property.

mWARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting.

mWARNING: Perform these leak checks even if your barbecue was dealer or store assembled.

You will need: a soap and water solution and a rag or brush to apply it.

To perform leak checks: Plug end of gas supply hose into the quick disconnect, then turn on gas supply.

mWARNING: Do not ignite burners while leak checking.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows there is a leak.

Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

Check:

a) Hose to manifold connection. Figure 3 (a).

mWARNING: If there is a leak at the hose to manifold connection, Figure 3 (a), retighten the hose fitting with a wrench and recheck for leaks with soap and water solution.

If a leak persists after retightening the fitting, turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact

Weber-Stephen Customer Service.

b)Valves to manifold connections. Figure 3 (b).

c)The hose to quick disconnect connection. Figure 3 (c).

mWARNING: If there is a leak at connections (b) or (c), turn OFF the gas. DO NOT OPERATE THE BARBECUE.

Contact Weber-Stephen Customer Service.

When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.

(a)

(b)

(c)

Figure 3

Inspection and Cleaning of the Weber Spider Stopper Guards

To inspect the Spider Stopper Guards, remove the control panel and look to see if they have dust or dirt on their outside surfaces. If they are dirty, brush off the outside surface of the Spider Stopper Guards with a soft bristle brush (an old toothbrush for example). Check that there are no gaps in the Spider Stopper Guards’ seams or in the fit around the burners or valves. (See Section "General Maintenance".)

25

Image 25
Contents Natural Gas Barbecue LP GAS Units only Warranty Patents and Trademarks Contents Gas supply testing For Installation in CanadaGeneral Instructions StorageCheck package contents AssemblyStep Page Check contents of hardware packs Assemble top frame Assemble wheel frameInstall tubing plugs Continue frame assemblyAdd front panel Add cooking box Install frame connector Install manifold bracketInstall gas supply General Specifications for PipingGas line piping Typical natural gas supply installation. FigureTest connections Check that all burner valves are off Install igniterConnect flexible hose to manifold Check for gas leaks Install the bottom tray Install Flavorizer Bars and Cooking GratesAdd tool holders, control panel and burner control knobs Install LidMWARNING The load limit for the swing table is 30 pounds Install swing tableComplete accessory installation To Extinguish LightingManual Lighting Cooking Periodic CleaningStorage and/or Nonuse PreheatingCast Iron Cooking Grates Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMWARNING Do not ignite burners while leak checking Main Burner Cleaning Procedure General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High position11-12 53 46-48 49 50 Parts List Final Word Thanks
Related manuals
Manual 40 pages 25.24 Kb

3000 LX specifications

The Weber 3000 LX is a premier natural gas grill designed for outdoor cooking enthusiasts who demand both performance and versatility. This grill stands out with its sleek design, robust build, and an array of innovative features that make grilling a delightful experience.

One of the main features of the Weber 3000 LX is its generous cooking area. With a primary grilling surface of 669 square inches, it allows you to cook for large gatherings with ease. The grill also includes a warming rack that adds an additional 198 square inches of space, ensuring that all your food remains warm while the other items finish cooking.

The 3000 LX is equipped with powerful burners that deliver a remarkable 60,000 BTUs of cooking power, providing consistent heat across the entire grilling surface. The grill features three stainless steel burners that offer a combination of performance and durability. The Infinity ignition system ensures the grill fires up reliably every time, eliminating the frustration of failed starts.

Weber’s unique Flavorizer bars are another highlight of this grill. These angled bars are designed to catch drippings that sizzle and smoke, infusing your food with rich, smoky flavors. This feature not only enhances the taste of your grilled items but also helps keep the burners cleaner by minimizing flare-ups.

The grilling experience on the Weber 3000 LX is further enhanced by its high-quality construction. The porcelain-enameled lid and cast-iron grates provide excellent heat retention and distribution, ensuring that your food is cooked evenly. Additionally, the grill includes an easy-to-read built-in thermometer, allowing you to monitor the internal temperature of your food without lifting the lid.

Another notable technology in the Weber 3000 LX is its modular grill system, which allows for customized cooking options. With interchangeable grilling tools and accessories, you can expand your culinary possibilities by incorporating pizza stones, griddle plates, and more.

For ease of use, the grill features foldable side tables that provide extra prep space when needed and can be tucked away when not in use. The grill is also equipped with a convenient storage cabinet, allowing you to keep your grilling tools organized.

Overall, the Weber 3000 LX combines innovative technology, thoughtful design, and superior performance, making it a top choice for any outdoor cooking enthusiast seeking to elevate their grilling experience. Whether you are an occasional griller or a seasoned pitmaster, this grill will exceed your expectations and make outdoor cooking enjoyable.