English
•When not in use, the appliance should be stored in a dry place. children should not have access to stored appliances.
Inspection and repairs
•Before use, check the appliance for damaged or defective parts. Check for breakage of parts, damage to switches and any other conditions that may affect its operation.
•Do not use the appliance if any part is damaged or defective.
•Have any damaged or defective parts repaired or replaced by an authorized repair agent.
•Before use, check the power supply cord for signs of damaged, ageing and wear.
•Do not use the appliance if the power supply cord or main plug is damaged or defective.
•If the supply cord is damaged, it must be replaced by the manufacturer or its service agent or a similarly qualified person in order to avoid a hazard.
•Do not cut the power supply cord and do not attempt to repair it yourself.
•Never attempt to remove or replace any parts other than those specified in this manual.
•Do not attempt to repair the appliance. Take it to your nearest Black & Decker - owned or authorized Services Centre for repair.
Double Insulation
This appliance is double insulated; therefore no earth wire is required.
Always check that the power supply corresponds to the voltage on the rating plate.
Additional Safety Instructions for Blenders
•Do not immerse the appliance, cord set or plug in liquids
•Always leave sufficient space around the appliance for ventilation.
•Keep loose clothing, hair, jewellery, etc. away from moving parts.
•Do not use the unit if you have wet hands or bare feet.
•Care is needed when handling cutting blades, especially when removing the blades, emptying, and during cleaning.
•Switch off the appliance before changing accessories or approaching parts which move in use.
Assembly
This appliance requires some assembly to complete the required task. Please refer to the relevant section for particular assembly details. All parts should be cleaned before use. see "Cleaning" for details.
Use
As a Blender
Place the appliance on a clean, flat work surface.
Assemble the jar (3) by first placing the sealing ring (5) on the blade assembly (4). Position the blade assembly in the jar base
(6). Fit the jar base (6) into the jar (3), rotating it in an
Warning! Do not
Place the assembled jar on the motor housing (7) and rotate it in a clockwise direction until it locks in position. 
To unlock rotate it in anticlockwise direction until it unlocks in position.
Add the ingredients to the jar then fit the lid
(2)and filter cap (1). The filter cap must be rotated clockwise to lock it in place.