As a Coffee Grinder, As a Cheese Grater

English

Note: Do not exceed the maximum capacity of 1.5 litres.

Connect the appliance to a suitable electrical supply. Rotate the switch (8) to the required speed. Pulse (P) can also be used to give greater control. When blending is complete, either release the pulse button, or return the switch to the off (0) position. Once the blades have come to a complete stop, rotate the jar (3) in an anti-clockwise direction and lift it from the motor housing

(7). Remove the lid (2). Pour the ingredients into a suitable container.

Note: Ingredients can be added by inserting them through the hole left when the filler cap (1) is removed.

Warning! Never operate the Blender without the lid (2) fitted.

Note: The blender will not operate unless the lid is correctly fitted.

Note: Do not operate the blender for longer than 2 minutes. After each 2 minute session the blender must be allowed to cool down for at least 10 minutes.

Note: The motor is equipped with an auto resetting thermostat. This may operate and stop blending if the appliance is over loaded. If this should happen, allow the blender to cool down and remove some of the contents of the jar. The thermostat will take a few minutes to reset.

As a Coffee Grinder

Remove the cover (13) from the coffee grinding attachment (11) by holding the cup

and rotating the cover in an anti-clockwise direction. Add a maximum of 40g of coffee beans to the cup. Place the cover on the cup & rotate it clockwise until it locks in place. Position the assembly on the motor housing (7), rotate it clockwise until it locks into place. Turn the knob to the required speed & allow the grinder to operate.

Note: The Coffee Grinder should not be run for longer than 20 seconds. After each 20 seconds use, the Coffee Grinder must be allowed to cool down for a least 3 minutes. This can be repeated 3 times before further use, the unit must be left to cool to room temperature.

As a Cheese Grater

Cheese should be cut into 15 mm cubes before grinding. Remove the cover (14) from the cheese grating attachment (12) by holding the cup & rotating the cover in an anti-clockwise direction. Add the prepared cheese to the cup. Place the cover on the cup & rotate it clockwise until it locks in place. Position the assembly on the motor housing (7), rotating it clockwise until it locks into place. Turn the knob to the required speed & allow the grater to operate.

Note: The Cheese Grater should not be run for longer than 20 seconds. After each 20 seconds use, the Cheese Grater must be allowed to cool down for at least 3 minutes. This can be repeated 3 times before further use, the unit must be left to cool to room temperature.

-6-