●After blending, some drinks may not be completely smooth due to seeds or the fibrous nature of ingredients.
●Some drinks may separate on standing, therefore it’s best to drink them straight away. Separated drinks should be stirred before drinking.
important
●Never blend dry ingredients (eg spices, nuts) or run the Smoothie Blender empty.
●Don’t use the blender as a storage container. Keep it empty before and after use.
●Some liquids increase in volume and froth during blending eg milk, so do not overfill and ensure the lid is correctly fitted.
●To ensure long life of your Smoothie Blender, never run it continuously for longer than 60 seconds.
●Never blend food that has formed a solid mass during freezing, break it up before adding to the goblet.
cleaning
●Always switch off, unplug and dismantle before cleaning.
●Never let the power unit, cord or plug get wet.
●Empty the goblet before unscrewing it from the blade unit.
●Always wash immediately after use. Don’t let food dry onto the goblet assembly as this will make cleaning difficult.
●Don’t wash any part in the dishwasher.
●Regularly dismantle the tap and clean the parts thoroughly. blender unit
Before dismantling the blender, half fill the goblet with warm water. Fit the lid and cap then place on the power unit. Switch to MIX and whilst running open the tap and allow the water to drain into a container to clean the valve. This can be repeated until the water runs clear. If further cleaning is necessary dismantle the unit first.
power unit
●Wipe with a damp cloth, then dry.
blade unit
1Remove and wash the sealing ring.
2Don’t touch the sharp blades - brush them clean using hot soapy water, then rinse thoroughly under the tap. Don’t immerse the blade assembly in water.
3Leave to dry upside down away from children.
lid, cap, stirrer
Wash by hand, rinse with clean water then dry.
cleaning the tap
Remove the tap assembly from the
goblet, then soak the tap in hot soapy water with the valve open .
Wash thoroughly then rinse and dry. Wash and dry the goblet then refit
the tap ensuring that the seals are correctly positioned on the goblet .
dismantling the tap
1Hold the tap by the lever. Push up on the plug whilst sliding the lever in the direction indicated .
2Unscrew the cap .
3Remove the spring .
4Push up on the plug on the inside of the tap and at the same time pull the plug from above .
5Wash all the components, then dry thoroughly.
6Reassemble the unit by reversing the above procedure.
4