PROGRAMMING MEMORY KEYS
1
–
6
The oven must be set on Program Unlock to perform the functions on this page (refer to page 12).
Programming Memory Keys for Single Portions
PROG 
PROG 
1
STAGE HIGH
PROG 
1 
STAGEDEFROST
PROG 
1 
STAGEDEFROST
PROG
1
STAGEDEFROST
1.Keep the door closed. Make sure the Display is blank. Program Unlock must be active (not Program Lock).
2.While pressing the START key, press the POWER LEVEL key. PROG will begin to blink in the Display.
3.Press the Memory key you wish to program 1 – 6 . For example, if you press Memory key 2 , [ A2 ] displays with the other currently programmed information for Memory key 2 .
4.Press POWER LEVEL to set the power level. The power level displays. Example: [ HIGH ] or [ DEFROST ].
5.Turn the Timer Dial until the desired time appears in the Display. Example: [ 14 00 ] indicates 14 minutes.
6.While pressing the START key, press the POWER LEVEL key. [ PROG ] stops blinking. This means that you have finished programming the selected Memory key.
7.Three seconds after programming is complete, the Display will return to blank.
Programming Memory Keys for Two-Stage Cooking
Use the procedure outlined above for programming single stage cooking and proceed through step 5. Then, repeat steps 4 and 5 before continuing with steps 6 and 7.
Programming the X2 Pad for Multiple Portions
Small Portions The X2 key is set at the factory to double the programmed time — this
is the correct setting for heating double portions of most small food items such as sandwiches, bowls of soup or slices of pie. No further programming is necessary. The maximum amount of time that can be doubled on HIGH power is 15 minutes; on DEFROST, 30 minutes.
Larger Portions To heat multiple portions of large platters or bulk food loads, set the time for slightly less than double the time required for a single portion.
The HM1200 incorporates a X2 Custom Program feature that allows
you to customize the heating time and/or power level for multiple portions of your menu items.
For example: If Memory key 3 is set for 6:00 minutes on DEFROST, touching the X2 key will display 12:00 minutes at DEFROST. If your own tests
have determined that the correct heating time for two portions is only 10 minutes and 30 seconds on DEFROST, the X2 Custom Program
feature can be programmed for 10:30 at DEFROST.
– 9 –