Hobart N50A dimensions Specifications, Motor

701 S Ridge Avenue, Troy, OH 45374

1-888-4HOBART • www.hobartcorp.com

N50 MIXER

SPECIFICATIONS

MOTOR:

1⁄6 H.P., Hobart designed, ventilated, sleeve bearing, drip-proof enclosure.

Single Phase	100-120V	2.9 Amps
	230V	1.4 Amps

ELECTRICAL:

100-120/60/1 - U L Listed for residential and ­commercial use. Also available in 100/50/1, 230/50/1, 220/60/1 and 230/60/1 - not ­submitted for U L Listing.

CONTROLS:

Single pole, toggle-type, mechanically interlocked with transmission shift handle. Includes automatic ­circuit breaker with manual reset switch.

TRANSMISSION:

Three speed selection transmission. Convenient shift handle mounted near “OFF” and “ON” switch.

SPEEDS:

Three positive speeds - Low, Intermediate, and High.

	Agitator	Attachment
	(RPM)	(RPM)
Low	136	60
Intermediate	281	124
High	580	255

BOWL AND BEATERS:

Bowl is 5-quart capacity stainless steel. Locks at top and bottom of lift travel, which is controlled by convenient hand lever. A stainless steel beater is also available.

FINISH:

Hybrid Powder Coat finish available in Hobart Gray.

STANDARD EQUIPMENT:

Consists of the mixer unit with one (1) 5-quart stainless steel bowl, one (1) “B” flat beater, one (1) “D” wire whip, one (1) “ED” dough hook, cord and plug.

ATTACHMENT HUB:

Equipped with front-mounted Hobart standard #10 taper attachment hub, and any #10 size attachments may be used.

ATTACHMENTS AND ACCESSORIES: The following are available at extra cost:

Stainless Steel Bowl “B” Flat Beater

Stainless Steel “B” Flat Beater “D” Wire Whip

“ED” Dough Hook

LISTED BY: Underwriters Laboratories, Inc. and NSF International.

F-7533 – N50 Mixer Page 3 of 4