TABLE OF CONTENTS
WARRANTY | xi |
SPECIFICATIONS | 1 |
FEATURES & OPERATING CONTROLS | 2 |
PRECAUTIONS & GENERAL INFORMATION | 4 |
AGENCY LISTING INFORMATION | 4 |
INSTALLATION | 5 |
OPERATION | 11 |
CLEANING INSTRUCTIONS | 12 |
DELIMING INSTRUCTIONS | 13 |
TROUBLESHOOTING SUGGESTIONS | 16 |
PARTS & SERVICE | 17 |
CUSTOMER SERVICE DATA | 17 |
INTRODUCTION
Thank you for purchasing this Wells Manufacturing Co. appliance.
Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life.
This manual contains the information needed to properly install this appliance, and to use and care for the appliance in a manner which will ensure its optimum performance.
SPECIFICATIONS
Electrical: 208 Volts, Single Phase 35 Amps
240 Volts, Single Phase 35 Amps
NOTE: Requires a dedicated 50 Amp circuit
Plumbing: Water Inlet: 1/4” Male Flare Fitting
Supply: 1/4” Female Flare supplied by a 1/4” O.D. or larger water supply line
NOTE: If water supply run from main supply line to
For higher capacity,
IMPORTANT: This dispenser must be installed in compliance with all applicable federal, state and local codes and ordinances.
Dimensions: Height: |
| |
Width: | 15” (with tank installed) | |
Depth: | ||
Weight: | 74 lbs. (without tank) | 150 lbs. (with tank installed and filled) |
1