Hobart FT900 SERIES manual DOs and DONTs for Your NEW Hobart Warewasher

Page 8

DOs AND DON'Ts FOR YOUR NEW HOBART WAREWASHER

DO assure proper water hardness of 4 to 6 grains per gallon.

DO pre-scrap dishes thoroughly.

DO use only detergents recommended by your chemical professional.

DO at the end of the day, thoroughly cleanse the machine, rinse, and dry (leave doors open).

DO closely follow your chemical professional's prescribed deliming schedule.

DO use only products formulated to be safe on stainless steel.

DO NOT over soften water (recommended water hardness range is 4 to 6 grains per gallon).

DO NOT use detergents formulated for residential dishwashers.

DO NOT allow food soil to accumulate on the tank bottom.

DO NOT exceed chemical manufacturer's recommended concentrations for detergent, sanitizer, rinse aid, or lime scale remover.

DO NOT use steel wool to clean ware or warewasher surface.

DO NOT allow foreign objects to enter the unit, especially metallic contaminants.

NOTE: Failure to follow use, care, and maintenance instructions may void your Hobart warewasher warranty.

– 8 –

Image 8
Contents Pera FT900 Series Dishwashers Operation Machine Preparation Check before beginning operationFill DishwashingRecommended Minimum Temperatures Empty Strainer Baskets During Operation as NecessaryLoading UnloadingCleaning Photoelectric Sensor Openings Cleaning the TOP Duct Cleaning the BLOWER-DRYER AIR FilterDOs and DONTs for Your NEW Hobart Warewasher Hang Curtains Operation with 8 Center SectionOperation with 4 Center Section Operation with 11 Center Section Lubrication Symptom Possible Cause Conveyor Speed AdjustmentManual Reset Button on Pump Motors and Conveyor Motor Clogged wash arm nozzles Flash on and off when blocking and unblocking the upper ServiceDate