Hobart FP400 manual Verify Correct Rotation, START-UP Testing

Page 5

VERIFY CORRECT ROTATION

Verify correct rotation of the knife shaft. Make sure it moves in a clockwise direction looking down into the feed cylinder. If the rotation is incorrect, UNPLUG THE ELECTRICAL CORD and interchange any two of the three power supply leads (non grounding wires) inside the plug. Then, verify that the rotation is correct.

START-UP TESTING

1.Check that the machine stops when the locking handle (Fig. 1) is pulled forward, unlocking the feed cylinder.

2.Check that the machine stops when the locking knob for the feed hopper attachment (Fig. 1) is turned clockwise to the unlocked position, and that the machine restarts when the locking knob is turned counterclockwise to the locked position.

3.Check that the machine stops when the pusher plate feed attachment (Fig. 2) is swung to the side so that the feed cylinder (Fig. 2) opening is larger than 11⁄4" (31.75 mm), and that the machine restarts when the pusher plate feed attachment is swung back over the feed cylinder.

If the machine does not perform correctly, call your local Hobart Service Office before using the machine.

LOCKING KNOB

LOCKING HANDLE

PUSHER

PLATE

FEED

CYLINDER

OPENING

PL-52964

PL-52965

Fig. 1

Fig. 2

– 5 –

Page 4 Page 6
Image 5
Page 4 Page 6
Contents Truct ONS Table of Contents Shown with Feed Hopper Attachment Model FP400 Food ProcessorUnpacking InstallationLocation LevelingVerify Correct Rotation START-UP TestingControls Fig OperationDicing and French Fries Installing the Cutting ToolsSlicing, Shredding, Grating, and Julienne Cutting Removing the Cutting Tools Installing and Removing the Feed Cylinder FigInstalling and Removing the Feed Attachments Feed Hopper Attachment Locking Knob Slicers Using the Food ProcessorGraters and Shredders Crimping SlicerJulienne Cutters Cleaning Service MaintenanceReplacement Dicing Grids Symptom Possible Cause Suggested Action TroubleshootingTroubleshooting Contd
Top Page Image Contents