Clearance and Ventilation, Power Requirements

SUPER RUNNER SERIES ELECTRIC FRYERS

CHAPTER 1: INSTALLATION INSTRUCTIONS

CLEARANCE AND VENTILATION

This fryer must be installed with a 6-inch (150-mm) clearance at both sides and back when installed adjacent to combustible construction. No clearance is required when installed adjacent to non-combustible construction. A minimum of 24-inches (600-mm) clearance should be provided at the front of the fryer.

INSTALLATION

For units equipped with legs: Lift the unit and move it into its final position. Do not drag or push the fryer into position. Doing so may damage the legs. Level the unit front to back and side to side. If the fryer is not level, the unit will not function efficiently.

A.Adjust leg height with an adjustable or 1-1/16-inch (27-mm) open-end wrench by turning the hexagon-shaped foot on the bottom of the leg. NOTE: The foot is for minor leg height adjustment only. Do not adjust outward more than ¾-inch(19-mm).

B.When leveling the unit, the leg body should be held firmly to keep the leg from bending or rotating while turning the foot to the required height.

For units equipped with casters: Roll the unit into its final position and lock the front casters.

When the fryer is leveled in its final position, install the restraints provided with the unit to limit its movement so that it does not depend on or transmit stress to the electrical conduit or connection. Install the restraints in accordance with the provided instructions (see illustration below). If the restraints are disconnected for service or other reasons, they must be reconnected before the fryer is used.

1.3 Power Requirements

	Use copper wire ONLY suitable for at least 194°F (90°C)
MODEL		VOLTAGE	PHASE	WIRE	MINIMUM WIRE		AMPS
				WIRE	SIZE		AMPS
				SERVICE	SIZE		(per leg)
				SERVICE	AWG	mm	(per leg)
					AWG	mm
14 kW		208	Single	3	4	(5.83)	68
14 kW		208	3	3	8	(4.11)	39
14 kW		240	Single	3	4	(5.19)	59
14 kW		240	3	3	8	(3.26)	34
14 kW		230/400	3	4	6	(4.11)	21

DANGER

The electrical power supply for this appliance MUST be the same as indicated on the rating and serial

number plate located on the inside of the fryer door.

DANGER

This appliance MUST be connected to the voltage and phase specified on the rating and serial

number plate located inside the fryer door.

DANGER

All wiring connections for this appliance MUST be made in accordance with the wiring diagrams

furnished with the equipment. Wiring diagrams are located inside the fryer door.

1-2