Frymaster CM4-S(T) warranty Follow these instructions if there is no oil disposal system

DANGER

Remove all drops of water from the frypot before filling with oil. Failure to do so may cause spattering of hot liquid when the oil is heated to cooking temperature.

Prepared for

CM4-S COMPUTER OPERATION

(PROGRAMMED FOR POPEYE’S)

Follow these instructions if there is no oil disposal system:

1.Press the button to turn computer OFF and allow the oil to cool to approximately 100°F (38°C).

2.Remove and clean the filter pan.

3.Position a shortening disposal unit or a metal container suitable to handle hot liquid under the drain valve.

4.Open the drain with the red-handled drain-valve lever. The shortening will flow out. Do not overfill the container. Repeat draining process as necessary.

5.Close the drain valve when all shortening is drained.

6.Fill the frypot to the top OIL LEVEL line with clean water.

7.Pour in boil-out cleaning detergent.

8.Press the programming key on the computer (See Figure 1).

9.CODE appears on the left display of the computer.

10.Enter 1115.

11.Boil Out appears in the left display. Press Check to Start appears in the right display.

12.Press the button.

13.Boil Out appears in the left display; a time display, which starts at 30:00, appears in the right and counts down the boil out.

14.The water/detergent solution heats to 195°F.

15.The computer displays DONE and beeps at the end of the boil out.

16. Press the button to turn

computer OFF.

17. Drain the boil-out solution into a metal stockpot capable of holding the complete contents of the frypot and discard.

18.Rinse frypot with clean water, drain into stockpot and dry the frypot.

19.Fill with fresh shortening to the lower OIL LEVEL line on the back of the frypot.

20.Replace the filter pan.

21.Press the button to turn the computer ON. The oil will heat.

6