Setting up your A32 integrated amplifier
‘Switch on’
state
DOWN UP
VOLUME
Adjust
LEFT RIGHT
BALANCE
Adjust
INTRODUCTION
The A32 allows you to adjust listening settings to suit your taste, and to customize various features of the amplifier to fit your system. Use this diagram to help you navigate through the settings available.
The ENTER and SELECT buttons are represented
in the diagram by the symbols and respectively.
The Control knob is shown as .
ADJUSTING LISTENING
SETTINGS
The default display mode is VOLUME, where the control knob is used to adjust sound level. Press SELECT to enter edit mode and cycle through the other sound settings: BALANCE, BASS and TREBLE.When a setting is selected, adjust it with the control knob. Press ENTER to fix the change you have made and return to default (volume) mode, or press SELECT again to move to the next setting.
BASS
Adjust
TREBLE
Adjust
Customize
Choose setting
CUSTOMISING AMPLIFIER SETTINGS
Press SELECT until the display shows
Press ENTER to confirm the adjustment or press SELECT to confirm the adjustment and move on to the next item.
Press ENTER twice to leave the Customize menu.
Volume Resolution
VOLUME DISPLAY
INPUT TRIMS
TONE CONTROL
WELCOME MESSAGE
PHONO/AUX TEXT
RESTORE SETTINGS
edit | edit | edit | edit | edit | edit | edit |
STANDARD | GRAPHIC/ | TRIM | GLOBAL/ | ARCAM Amp | AUX/ | NO/YES |
FINE | NUMERIC |
| PER |
| PHONO |
|
REFERENCE |
|
| SOURCE |
|
| ‘Switch on’ |
|
|
|
|
|
| state |
continue | continue | continue | continue | continue | continue |
|
Volume Resolution | Volume Display | Input Trims | Tone Control | Welcome Message | Phono/Aux Text | Restore Settings |
Volume Resolution – Standard, fine or Reference. ‘Standard’ and ‘Fine’ represent different levels of volume control sensitivity.The ‘Reference’ setting gives absolute increments in 0.5dB steps.
Volume display mode – graphic or numeric shows the volume either as a bar graph or as a number. If Volume resolution is set to ‘Reference’ a numeric volume display shows the actual decibel figure.
Input Trims – use the source select buttons and Control knob to set input trims for each source. Input trims are used to compensate for variations in output levels of different source equipment.
Tone Control – Global or Per source. This specifies the scope of changes for ‘Bass’ and ‘Treble’ tone settings. The default setting is ‘Global’ which affects all inputs equally. ‘Per source’ allows you to set tone controls for individual inputs: once set, the amplifier remembers tone settings for each input.
Welcome message – You can change the power on Welcome message from ‘Arcam Amp’ to
display your name, postcode, etc.When customising the message, use the UP and DOWN buttons to select the cursor position and the Control knob to change the letter.
Phono/Aux Text – If you have had the optional Phono module added, choose ‘Phono’ so this word is displayed when the input is selected.The default is ‘Aux’.
Restore Settings – this restores all amplifier settings, including Input trims and the Welcome message, to their factory defaults.
9