_,_NSTALLATION INSTRUCTIONS, CONT.
How TO REPLACE | THE | How | TO INSTALL AND | WHAT IF I AM | |||
DOOR AND | HINGES |
| REMOVE PANELS | INSTALLING RAISED | |||
I. Install | center | hinge with | Phillips | (SOME | MODELS) | PANELS? | |
|
|
|
|
|
| ||
| screws. |
|
|
|
|
| Pleaseseerecommendeddimensionsfor |
|
|
|
|
|
|
| |
2. | Install stabilizing brackets with _" hex |
|
| paneling.All panelholesare ¼ dtameten | |||
|
|
|
|
|
|
| 2679- |
3. | Replace | center |
|
|
| 73cm | |
|
|
| H | ||||
| head screws. |
|
|
|
| ||
| hinge pin. |
|
|
|
|
| |
4.Place hinge side of
refrigerator door on center hinge pin.
5. While holding
upright, tighten
down top hinge refrigerator door with Y_"hex head
driver.
6.Install top door trim of fresh food door with a Phillipsscrewdriver.
TO INSTALL PANELS:
I. Perform the handle removal
instructions in How to Install and
Remove the Handles, including instructions to remove mounting posts from door face.
2.Remove top door trim.
3.Remove handle side door trim.
4.Slidepanel in the handleside of door, by usinggroovesprovided by bottom door cap andside door trim.
,Replace mounting posts, handles,and trim.
TO REMOVE PANELS:
I. Perform the handle removal instructionsin How to Install and
Remove the Handles, including instructions to remove mounting
posts from door face.
2, Removetop door trim.
3.Removehandleside door trim.
4.Slide panel out the handle side of door.
How Do I MOUNT
HANDLESON RAISED
PANELS?
The refrigerator is shipped with the handle mounting posts attached to the door with ¼" hex head screw that is
approximately 1½" long. This length is necessary to safely secure the mounting post to the door.
If handlesare beingmountedto a raised surface,the factory supplied hex head screws will haveto be replaced with a
longerversionTo. determine how long
the replacementscrewmusthe,add the thicknessof the raisedpanelto the 1½"
measurementSee examplebelow.
i ,_mlL_ | I" thick | raised |
panel = 2½ | long | |
|
|