How TO REMOVE AND
INSTALL THE PULLOUT
DRAWER
To remove:
3.Pulldrawer open to full extension.
4.RemovePhillipsscrew from eachside of rail system. (Somemodels)
]
i
5. Lift top of door to unhook door supports from rail system. Lift door
OUt tO remove,
3.Lower door into final position.
4.Replace and tighten Phillips screws that were removedfrom each side of
rail system.
\\
5. With drawer pulled out to full |
extension, insert lower basket by |
aligningtabs on both sides of lower |
basket with notches in rail assembly. |
Verify that the basket sides are |
hooked securelyover the rails. |
I.Pull upperbasketout to full extension andlift out to remove.
2.Remove lower basket by pressing inward on basket sides, then lift basket
PressTab Here
\
To install:
I.Pull both rails out to full extension.
2.While supporting door, hook door
supports into tabs locatedon inside of rail.
L
6.Slide upper basket into freezer.Make sure that rear of baskethooks behind rail catch.