Installation
If the adjacent cabinetry (or appli- ance) does not have drawers and alignment to a drawer line is not possible:
^Hang the bracket on the machine door, without the templates. Tighten the four locking screws on the edges of the door panel.
^Close the door.
^Measure the distance from the adja- cent cabinet’s (or appliance) door bottom to the bottom of the mounting bracket (X).
^Draw a line on the rear of the door panel (X) inches up from the bottom.
^Remove the bracket from the ma- chine door and place it on the rear of the door panel so that:
–the bracket is centered left to right,
–the bottom of the bracket is aligned with the (X) line.
^Tape the bracket to the door panel to hold it in place while the mounting holes are drilled.
^Drill pilot holes for the screws using a 3/32" (2.5 mm) bit.
^Attach the bracket to the panel using the 6 screws provided.
24
