Installation |
^Place a template on each end of the mounting bracket as shown, making sure the rule marks face the outside of the bracket.
^Hang the mounting bracket on the machine door.
^Slide the top edge of the templates under the filler strips and control panel.
^Slide the bracket up or down until the oblong holes on the machine door line up with the oblong holes on the template (shown in inset a).
^Draw a line on each template that is even with the top edge of the adja- cent cabinet door (inset b).
^Remove the bracket from the door.
^Place the door panel on a flat sur- face, good side facing down, taking care not to scratch the surface. Make certain that the bottom of the panel is closest to you.
^Place the bracket on the back of the door panel and adjust it so that:
–the lines drawn on the templates align with the upper edge of the door panel.
–the mounting bracket is centered (left to right) on the door panel.
21
