Installation
5. Level the legs
^The rear leveling legs can be ad- justed with a T20 Torx screwdriver by turning the screws at the front of the slide skis.
To raise the machine turn clockwise. To lower the machine turn counter clockwise.
Several turns may be needed to set the correct height. Do not use a power screwdriver.
^Adjust the front leveling legs by pushing on the feet with a slotted screwdriver.
^Tipping the machine slightly back- wards, if possible will make adjusting the front legs easier. Make sure the machine is level when adjustments are complete.
The dishwasher should be raised until it just touches the underside of the countertop.
If you are installing a prefinished unit dishwasher proceed to step 9.
If you are installing a factory made door panel (GDU Decor Set), refer to the instruction manual enclosed with the panel at this time.
14
