Installation
4.Install the dishwasher under the countertop
The dishwasher must be installed so that the water and electricity supplies can be accessed through an adjacent cabinet. The supplies must not be lo- cated behind the machine.
The floor of the cut out where the dish- washer will be installed should be even in height with the surrounding kitchen floor. Plywood can be secured to the floor to make the two areas even.
^Make a 2" x 4" (5 x 10 cm) cut out in the side or bottom of the cabinet ad- joining the dishwasher. This cut out is necessary for connections to pass through.
^Make certain that there are no rough edges that could damage the power cord or hoses. If metal cabinets are used, place the supplied rubber grommet around the edge of the ope- ning before passing the cable through.
^Slide the machine into the opening, making sure the electrical cable and hoses can reach their connection points without kinking.
The drain hose connection at the rear of the dishwasher can be turned to allow the hose to be angled to the right or left.
Exercise care when sliding the dish- washer in or out, to prevent damag- ing the power cord or hoses.
13
