]]Oven Operation
• • | • • • • • • • • • • • • • • • • • • 41. • | • • • • • • | • • • • • • • • • • • |
Probe |
|
| |
To assure excellent results every time when roasting, use the |
|
| |
probe | supplied with your wall oven. | " | ° |
• _The probe must be removed from the oven when it is
Installing and Setting the Probe
1. Insert the probe into the food item. (For meats, the probe
tipshould be located in the center of the thickest part of the meat and not into the fat or touching a bone.)
2. Insert the probe plug into the receptacle located on the top
left of the oven. Be certain to insert plug into the recep- tacle all the way.
serted, the indicator word PROBE will flash and a beep will sound reminding you to enter the desired probe temp-
•After the probe is in- erature.
3.Press Probe pad. The display will show three dashes.
4.Press the appropriate number pads to set the internal temperature desired. (Allowable range is 100° to 200°F.)
•After five seconds the display will show probe
temperature or 95 ° , whichever is higher. Indicator words CONV, BAKE, ROAST will flash.
5.Press Bake or Convect Roast pad. The display will show three dashes.
6.Press the appropriate number pads for desired oven tem- perature.
7.When the selected internal temperature of the food has been reached, the oven will shut offand a chime will sound
four times. Plus, the actual probe temperature will flash and the word "End" will be shown in the display.
A chime will sound every minute for 10 minutes or until the Cancel pad is pressed.
•If the probe is not removed, a beep will sound continuously until the probe is removed. (Hold probe plug with a potholder when removing from the oven.)
be usea.
•Because of the excellent insulation of the oven, the retained heat Continues to :cook the 'food after the
signal has sounded and the oven has cycled off. For this reason it is important to [emove the food from the
Oven as soon as the signal sounds,
•Use the handle of the probe for inserting or removing. Do not pull on the cable. Use a pot,holder to remove
•For frozen meats, insert probe after
•To clean cooled probe, wipe with a soapy dishcloth.
since probe becomes hot.
Do not submerge probe in water.