Jenn-Air Dual Fuel Cooktop dimensions Connecting Appliance To Electricity, Proper Electric Supply

Page 3

Connecting Appliance To Electricity

Electrical Wiring Information

The neutral of this unit is grounded to the frame through the green grounding wire. If local conditions do not permit

grounding of the neutral, untwist or disconnect the green wire and connect the green wire to ground in accordance with local

codes. Connect the white neutral to the service neutral.

Proper Electric Supply

You must provide an adequate electrical supply system as required for your cooktop. All wire connections must be in accordance with local codes and properly insulated. Check with local utility for voerning electrical codes and ordinances, In the absence of local electrical codes, the National Electrical Code, NFPA No. 70, governing electric cooktop installations must be followed. A copy of the National Electrical Codes, NFPA No. 70, can be obtained by writing to:

NATIONAL FIRE PROTECTION ASSOC.

Batterymarch Park

A three-wire, single phase, A.C. 120/240 volt 60 cycle electrical system (properly circuit protected to meet Local Codes of NFPA No. 70) must be provided. Unit must be properly grounded in accordance with local wiring code. The chart below recommends the minimum circuit protector and

Quincy, Massachusetts 02269

wire size if the appliance is the only unit on the circuit. If smaller sizes of wire are used, the unit efficiency will be reduced and a fire hazard may be created. It is advisable that the electrical

wiring and hookup be accomplished by a competent electrician.

RECOMMENDEDMINIMUM

K.W. RATING CIRCUIT PROTECTION WIRE SIZE,

ON SERIAL PLATE

IN AMPRES

AWG

0-

4.9

20

12

5.0-

6.9

30

10

7.0-

9.9

40

8

10.0 - 11.9

50

8

12.0 - 14.9

60

6

Remove attachmentscrew and cover from junctionbox.

Connect BX cable power supply to knockout in side of box. Make wire connections, push wires into box. Re-attach cover. Consult local codes for proper power hookup. (Figure 3).

._ "

.__

t_,_/

(_

Box

CABLE j/

F lure 3

Connecting Appliance To Gas Supply

A TRAINED SERVICEMAN OR GAS APPLIANC

INSTALLER MUST MAKE THE GAS SUPP[

CONNECTION. Leak testing of the appliance shall t conducted by the installer according to the instructior given.

1.Install a manual shut-off valve in an accessible location the gas line external to this appliance for the purpose

shutting off gas supply to this appliance.

2.Install the appliance pressure regulator supplied with th

appliance to the threaded gas inlet of the manifold pip( taking care to observe proper direction of gas flow throug the regulator. Tighten to 20 to 30 ft.-Ibs, of torque.

3.Connect the inlet of the appliance pressure regulator to th shut-off valve using a 1/2" NPT pipe nipple of appropriat length and additional pipe fittings, as required.

Use an approved pipe joint compound that is resistant to th action of LP gas on all external pipe threads when makin these connections.

APPLA,CEPR______

REGULATOR, SUPPL IEO

(OBSErvEDIRECTION

OFGASFLOWARROW)I

}

I

 

I

 

I

UNmN

 

 

_2" ,_T

ADAPT

 

 

PI PE

FLARED_

 

 

HI PPLE

 

 

 

_LEXIBLE.--_.f_

 

 

APPL IANCE

 

 

 

CONNgCTO

 

 

 

(5 FT. MAX)

_-

 

___ _--GAS

FLARE

_

 

SHUT-OFF

 

VALVE

ADAPT

 

 

 

UN IONoR-_

_

 

 

SHUT-OFF

 

 

P I PE

GASF_._ __

 

_1"/--1/2" NPT

VALV

 

 

 

P_PE

1/2" NPT_

Figure 4: Alternative Gas Connections

A new, A.G.A.-certified, flexible metal appliance connector

4.) The flexible connector should have a diameter of 1/2" flare union adapter is required at each end of the flexible connector. CAUmay beTION:usedDto connectnot attemptthis applianceto atta h tothetheflexiblegas supplyconne(figurector directly to an external pipe thread.

IMPORTANT

Apply a non-corrosive leak detection fluid to all joints and fittings in the gas connection between the supply line

inshutthe-off valvrangeandif theconnectionsrange. Includeweregasdisturbedfittings andduringjoints

fittingsinstallationand. Cconnectionsheckforleaks!will bubblesindicate appeleakring.If aroundleak appears, turn off supply line gas shut-off valve, tighten connections, turn on the supply line gas shut off valve, and retest for leaks, Never test for gas leaks with an open flame.

3

Image 3
Contents 20.3 54 ¢m 1 cmMI N 22 .5 4 ¢m 20.64Location Of Your Jenn-Air Appliance Installing Cabinetry Over Your CooktopInstallation Of Appliance Important Installation SuggestionsProper Electric Supply Connecting Appliance To ElectricitySave the orifices removed from the appliance for future use Converting Appliance For Use With LP GasInvert Cap in Appliance Pressure Regulator Installation of LP Orifice SpudsReplace all orifice spuds Installation of Natural Gas Orifice SpudsNatural Gas To Convert Appliance For Use With

Dual Fuel Cooktop specifications

The Jenn-Air Dual Fuel Cooktop exemplifies culinary innovation, combining the precision of gas cooking with the even heat distribution of electric cooking. This premium appliance is designed for home chefs who demand performance and sophistication in their kitchen.

One of the standout features of the Jenn-Air Dual Fuel Cooktop is its dual functionality. It combines powerful gas burners with an electric induction cooktop, allowing for a versatile cooking experience. The gas burners provide instant heat and intuitive temperature control, perfect for techniques such as sautéing, while the induction element provides fast, responsive cooking with remarkable energy efficiency. This dual system ensures that every type of cooking is catered to, from simmering delicate sauces to searing meats.

The cooktop is equipped with a range of burner sizes, including a high-output burner for rapid boiling and a simmer burner for gentle heating. The precision of the gas burners is further enhanced with Jenn-Air's proprietary technology, which ensures reliable ignition and flame stability. Each burner is designed for optimal performance, with features like continuous grates that allow for easy movement of pots and pans, enhancing cooking efficiency.

In addition to its powerful cooking capabilities, the Jenn-Air Dual Fuel Cooktop boasts an intuitive user interface. The sleek controls are designed for ease of use, with precise temperature adjustments and easy-to-read indicators. The cooktop surface is constructed from high-quality materials, providing durability and a modern aesthetic that complements any kitchen decor.

Safety is also paramount in the design of the Jenn-Air Dual Fuel Cooktop. It features advanced safety technologies, including automatic shutoff and a flame sensing system that quickly detects if the flame goes out. These features provide peace of mind while cooking, ensuring a secure cooking environment.

Furthermore, convenience is at the forefront of this cooktop's design. Cleaning is effortless with its smooth surface and seamless edges that prevent food from getting stuck. The cooktop is designed to resist scratches and stains, keeping it looking pristine even after frequent use.

Overall, the Jenn-Air Dual Fuel Cooktop offers a perfect blend of technology, safety, and style. Its innovative features and elegant design make it an excellent addition to any kitchen, catering to both casual cooks and culinary enthusiasts alike. With this cooktop, users can elevate their cooking experience to new heights, enjoying the best of both gas and electric cooking in one sophisticated appliance.