Jenn-Air Essential Guide for Adjusting Pressure Regulators and Flame Settings

Page 9

B. INVERT CAP IN APPLIANCE PRESSURE REGULATOR (See figure 11)

With the appliance installed, the appliance regulator should be located as shown in figure 3, 4 or 5.

CONVERSION OF APPLIANCE

PRESSURE REGULATOR

FIGURE 11

C. LOW FLAME ADJUSTMENT (See figure 12)

This appliance is shipped from the factory with low and high flame settings adjusted for use with natural gas. To set for use with LP proceed as follows:

1. Remove control knob from valve stem.

CAUTION: NEVER USE A METAL BLADE TO PRY KNOB OFF. IF KNOB CANNOT BE EASILY REMOVED, TUCK THE FOLDS OF A CLOTH DISHTOWEL UNDER THE KNOB AND PULL THE TOWEL UPWARD WITH STEADY, EVEN PRESSURE.

2.Carefully remove rubber grommet.

3.Locate the valve adjustment screw. See figure 12.

4.Insert a slender, thin-blade screwdriver into knob hole and engage blade with slot in adjusting screw.

5.Turn the adjusting screw clockwise until tight (5-7 in-lbs max.). Do not over tighten.

6.Replace rubber grommet and control knob.

7.Repeat for remaining burners.

After adjusting the screw the burner should produce a stable, steady blue flame of minimum size. The setting should be checked by turning knob from high to low several times without extinguishing the flame.

This operation will automatically provide the proper flame size at medium setting.

After Conversion Steps A, B and C have been completed, check the appearance of each burner flame at the Hi and Lo settings against figure 13. If the flames appear too large or too small, review each step to make sure it was completed correctly.

FLAME APPEARANCE AT HI, MED AND LOW

KNOB

FIGURE 12

KNOB HOLE

FIGURE 13

High Altitude Notice

(KNOB AND GROMMET

REMOVED)

The specified gas burner ratings typically apply to elevations up to 2000 feet. For higher altitudes, the rates may need to be reduced to achieve satisfactory operation. A local certified gas servicer will be able to advise if a reduction is necessary.

9

Image 9
Contents Dimensions Cutout Dimensions Are Critical8101P736-60 InchesRequired Adjustments At Time Of Installation Installing Cabinetry Over Your Jenn-Air CooktopLocation Of Your Jenn-Air Appliance Preparation Of CountertopMobile Homes Installation Of ApplianceRecreational Park Trailers Commonwealth Of MassachusettsConnecting Appliance To Gas Supply If no Other Appliance is to be Installed below this CooktopIllustrative GAS Supply Piping Wall Oven Installed below 30″ Cooktop Illustrative Alternative Piping Pressure TestingElectrical Grounding Instructions Electrical Wiring InformationConverting Appliance For Use With LP Gas Installation Of LP Orifice SpudRemoval of Orifice Spud Replace ALL Orifice SpudsHigh Altitude Notice LOW Flame Adjustment See figureConversion of Appliance Pressure Regulator Invert CAP in Appliance Pressure Regulator See figureReset the Valves for Natural GAS Installation Of Natural Gas Orifice SpudsTo Convert Appliance For Use With Natural Gas Burner Model 36″ WideBurner Performance Burner Model 36″ WideInput Rates Natural GAS / LP GAS BTU/HR Burner Location How To Remove Cooktop For Servicing Service-Parts InformationHolding Unit Down To Countertop Pulgadas DimensionesPreparación de la superficie para cocinar Ubicación de su electrodoméstico Jenn-AirSugerencias importantes de preparación Ajustes necesarios al momento de la instalaciónRemolques de recreación Casas móvilesInstalación del electrodoméstico En la Commonwealth de MassachusettsIlustración DE LA Tubería DE Suministro DE GAS Conexión del electrodoméstico al suministro de gasNota, en referencia a la Figura 4, anterior Ilustración DE LA Tubería Alternativa Pruebas de presiónInstrucciones eléctricas de conexión Tierra Información de alambrado eléctricoPara Quitar LA Copa DE Orificio Conversión del electrodoméstico para usarse con gas LPInstalación de la copa de orificio LP Reemplace Todas LAS Copas DE OrificioConversión DEL Aviso de altitudRegulador DE Presión Inversión DE LA Tapa DEL Regulador DE Presión Vea la figuraInstalación de las copas de orificio de Gas natural Invierta LA Tapa DEL Regulador DE PRESIÓN. Vea la figuraReajuste LAS Válvulas Para GAS Natural Desempeño de los quemadores Para sujetar la unidad al mostrador Cómo quitar la superficie para cocinar para darle servicioInformación de las piezas de servicio Pouces Manuel DERéglages requis lors de la mise en service Emplacement de votre appareil ménager Jenn-AirPréparation du comptoir Suggestions importantes pour la préparationRoulottes de parc Maisons mobilesPose de l’appareil Dans le Commonwealth du MassachusettsIllustration D’UNE Conduite DE GAZ Raccordement de l’appareil à l’alimentation en gazCuisson DE 30 PO 76,2 CM Four Mural Monté Sous LA Plaque DEIllustration D’UNE Méthode Alternative Vérification de la pressionMise à la terre Câblage électriqueDépose DE L’ÉCROU À Orifice Conversion de l’appareil au gaz GPLPose de l’écrou à orifice pour gaz GPL Remplacer Tous LES Raccords À OrificeConversion DU Utilisation en haute altitudeDétendeur DE L’APPAREIL Inverser LE Capuchon Dans LE DétendeurRégler LES Boutons DE Commande AU GAZ Naturel Pour convertir l’appareil au gaz naturelPose de raccords à orifice pour gaz naturel Débits DE GAZ GAZ NATUREL/GPL BTU/H Emplacement DU Brûleur Fonctionnement des brûleursHi plein feu Informations sur les pièces de rechange Fixation de l’appareil au comptoir

JGC1430 & JGC1536 specifications

Jenn-Air is renowned for its high-quality kitchen appliances, and among its notable offerings are the JGC1430 and JGC1536 gas cooktops. Both models stand out for their performance, elegance, and innovative features, catering to both everyday cooks and culinary enthusiasts.

The Jenn-Air JGC1430 is a 30-inch gas cooktop that combines functionality with style. It features four sealed burners, providing a variety of heat output options to accommodate different cooking needs. The two high-output burners are perfect for quickly boiling water or searing meats, while the two lower-output burners ensure even simmering for delicate sauces. The cooktop’s continuous cast-iron grates allow for smooth movement of pots and pans across the surface, enhancing the cooking experience.

On the other hand, the JGC1536 offers a 36-inch surface area, perfect for larger kitchens or those who require more cooking capacity. This model features five sealed burners, including dual burners that enable precision cooking with a wide range of heat settings. The additional burner provides flexibility when preparing multiple dishes simultaneously. Like the JGC1430, the JGC1536 is equipped with continuous grates and sturdy construction, ensuring durability and ease of use.

Both cooktops boast the innovative Jenn-Air performance technologies. The powerful flame technology delivers robust heat, allowing for efficient cooking and consistent results every time. The appliances also feature precise simmer settings, providing the ability to maintain low heat for extended cooking, which is ideal for sauces and delicate dishes. The oven-like design of the burners enhances heat distribution, ensuring that food is cooked evenly.

Another standout feature of both models is the easy-to-clean design. The sealed burners prevent spills from leaking underneath, while the smooth surface allows for effortless wiping down after cooking. Additionally, the sleek stainless steel finish adds a modern aesthetic to any kitchen.

Safety is a significant consideration in Jenn-Air design as well. Both models include features such as electronic ignition and flame failure detection, ensuring that the burners will automatically shut off if the flame is lost, providing peace of mind during use.

In conclusion, the Jenn-Air JGC1430 and JGC1536 gas cooktops exemplify the brand's commitment to quality, performance, and user-friendly design. With their powerful burners, innovative technology, and stylish aesthetics, these models are ideal choices for anyone looking to elevate their cooking experience.