Jenn-Air CVG4100, CVG4380, CVG428, 0VG4280 manual

Page 20

Jenn-Air's ventilation system is designed to capture both cooking fumes and smoke while grilling. If the system does not, these are some ducting installation situations to check:

•6" diameter round or 31/4" x 10" rectangular ducting should be used for duct lengths 10'-60'Note:. 5" diameter round ducting must be used if the duct length is 10' or Jess.

•No more than three 90 ° elbows should be used. Distance between elbows should be at least 18".

•Recommended Jenn-Air wall cap should be used. Make sure damper moves freely when ventilation system is operating.

•There should be a minimum clearance of 8" for eooktop installed near a side wall.

If there is not an obvious improper installation, there may be a concealed problem such as a pinched joint, obstruction in the pipe, etc. Installation is the responsibility of the and questions should be addressed first by the installer. The installer should

very carefully check the ducting installation instructions.

21

Page 19 Page 21
Image 20
Page 19 Page 21
Contents MBmJENN-AIR What to do if YOU Smell GAS Read before operating your cooktop Gas leak Important Safety Notice and Warning Jenfl-Air Customer Assistance Important do not Operate System Without Page Surface Burners Lo Flame Adjustment INSLOTAND%VISTWITHLeft Side or Single Grill Page Page Should sustained flare-up occur Never Leave Grill UNAI-rENDEDDURING Grill OperationPreheat grill on Hi, 5 or 10 minutes, for best flavor Page Page Page Serial Plate Do notclean Page If grill or surface burner fails to light If the flame is unevenIf grill or surface burner flame lifts off the ports If grill or surface burner flame is yellow in colorSurface Burner Module Model AG202
Top Page Image Contents