Cadco OV-400, OV-250 Installation Location, Electrical Connection, Remove the Protective Film

ENGLISH

3.2INSTALLATION LOCATION

Make sure you have the correct power sup- ply for the oven model you have purchased. Check the technical data sheets at the back of this manual if you are in doubt.

Do not install any Cadco-Unox Convection Oven directly on the floor. Cadco has oven stands to perfectly elevate your oven as well as provide pan storage.

OST-34A for models OV-350 and OV-400 OST-56A for models OV-500 and OV-600

If the oven must be placed near walls, dividers, or moldings Cadco recommends they be made of non-combustible materials. Be sure to observe all safety and fire codes when positioning your convection oven.

All of our convection ovens have a vapor vent in the back of the unit. When installing your convection oven, leave a space of 4” [mini- mum] between the back of the oven and the wall, and 2” minimum on the top and sides. Where applicable, ventilation hood require- ments vary according to local codes.

We do not suggest using the Cadco-Unox

exterior walls before you begin cooking food in your new Cadco convection oven. Most solvents or degreasers will remove any residue.

4.INSTALLATION

4.1ELECTRICAL CONNECTION

The connection to the electrical power supply network must be done according to the stan- dards in force.

Before connecting make sure that the voltage and the frequency correspond to that stated on the data plate on the oven.

Place a bi-polar switch between the oven and the network accessible after installation, whose contacts have a minimum opening distance of 0.1 inches, with an appropriate input (for example, magnetothermal switch). When the oven is in operation, the power supply voltage must not vary from the value of the nominal voltage by more than ± 10%. The oven must be connected to the ground line of the network.

208-240VXA030/OV-400

Convection Ovens for built in applications.

Measure to make sure that your new oven will fit in your available space.

3.3REMOVE THE PROTECTIVE FILM

Be sure to remove the laser film from the

L2

XA085/OV-500

4ENGLISH

L2

XA006/OV-250

XA015/OV-350

	08 -
		220-230240V ~
1			2		3	4		5	XA090/OV-600
									Use only AWG10 cords
				L	L