Bloomfield 8748 manual Maintenance

Page 9

7.Set the tank back into the brewer. Reassemble the tank lid to the water tank. Make sure the gasket is properly in place, then reinstall the hold-down strap.

8.Reinstall wiring to heating element and thermostat. Reinstall the hi-limit thermostat (if removed). For brewers with hot water faucet, reassemble faucet piping. Verify that all internal components are dry, then reinstall the top panel.

10.Reconnect brewer to electrical supply and, for automatic brewers, reconnect water supply.

11.Install the brew chamber without filter paper or grounds. Run at least three full brew cycles and discard all water generated.

12.Brewer is ready to use.

MAINTENANCE (continued)

NOTE: Normally, silicone hoses do not need to be delimed. Should deliming hoses become necessary, Bloomfield recommends replacing the hoses.

7

Page 8 Page 10
Image 9
Page 8 Page 10
Contents General Operation Guide for TEA Brewers Shipping Damage Claims Procedure Warranty StatementTable of Contents Troubleshooting SuggestionsKeep IT DRY General USE and CareElectric Shock Hazard Precautions and General InformationBrewing TEA Cleaning Procedure Clean Tea BrewerChemical Burn Hazard MaintenanceMaintenance Survival Guide Troubleshooting SuggestionsAuthorized Bloomfield Service Center Contact Address Phone #
Top Page Image Contents