Kramer Electronics WP-500 user manual Cond Dyn

Page 10

Using Your WP-500

5.1.1Connecting the Microphone

You can connect either a dynamic or a condenser microphone to the MIC IN 3.5mm mini jack.

Before connecting the microphone, set the microphone mode switch to dynamic or condenser (by default, this switch is set to dynamic).

The Dyn/Cond mode switch is located behind the front panel on the lower left side of the MIC IN 3.5mm jack, as illustrated in Figure 5.

It is recommended to set the mic mode switch before mounting the WP-500front panel.

Cond

Dyn

CV

Dyn/Cond Mode Switch

Figure 5: Setting the Microphone Mode Switch

When disconnecting the microphone or switching it OFF, turn the

microphone volume adjustment knob to the left (MIC mute).

When using the microphone, pay attention to the placement of the speakers. By placing the speakers properly, the chance of getting audio feedback is minimized.

8

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Page 9 Page 11
Image 10
Page 9 Page 11
Contents Model Contents TablesGetting Started IntroductionOverview Overview Select ON/OFF Defining the WP-500Video CV WP-500 Rear Panel Features Using Your WP-500 USB PortConnecting the WP-500 Front Panel Connecting the WP-500 Rear Panel Cond Dyn Configuration Setup Example Operating the WP-500Technical Specifications Technical Specifications 1 of the WP-500Limited Warranty 2900-000623 REV
Top Page Image Contents