Kramer Electronics user manual Using Your WP-500, USB Port

Using Your WP-500

4.1 The USB Port

Use the USB port to configure1 the unit. You can access the USB port by removing the two adjustment knobs and unscrewing the four front panel screws.

5 Using Your WP-500

This user manual is applicable once the unit is installed and configured2. The installation process is not detailed in this user manual, and includes configuration via the Kramer K-Config Windows®-based configuration software.

This section describes how to:

•Connect the WP-500(see section 5.1)

•Control the WP-500(see section 5.2)

5.1Connecting the WP-500

To connect the WP-500, as illustrated in the example in Figure 3 (front panel) and Figure 4 (rear panel), do the following:

1.On the front panel (see Figure 3), connect:

A computer graphics source and the audio source of the computer to the PC 1 15-pin HD and 3.5mm mini jack, respectively

A computer graphics source and the audio source of the computer to the PC 2 15-pin HD and 3.5mm mini jack, respectively

A composite video source (for example, a DVD player) and the audio source of that composite video source to the VIDEO (PC) RCA and AUDIO LEFT and RIGHT RCA connectors, respectively

A microphone to the MIC IN 3.5mm mini jack (see section 5.1.1)

1 By the system integrator only

2 By authorized Kramer technical personnel or by an external system integrator

5