Kramer Electronics user manual Connecting the WP-500 Front Panel

Page 8

Using Your WP-500

Figure 3: Connecting the WP-500 Front Panel

2.On the rear panel, connect the display device (for example, a projector) as follows. Connect the:

VGA (PC) OUTPUT to the PC Graphics (15-pin HD connector or RGBHV connector) input on the projector

VIDEO OUT output (VIDEO OUT, GND) to the video input on the projector

AUDIO OUT 1 and AUDIO OUT 2 outputs to the audio input of the video and PC inputs on the projector1

RS-232 port to the PC control port of the projector and/or the IR OUT to the IR receiver of the projector

3.Connect the ETHERNET port to a PC for configuration and control (not shown in Figure 4), see section 5.2.

1 You can connect either AUDIO OUT 1 or AUDIO OUT 2 to either the PC or the CV input of the projector since both audio outputs are identical

6

KRAMER: SIMPLE CREATIVE TECHNOLOGY

Image 8
Contents Model Contents TablesOverview IntroductionGetting Started Overview Video CV Defining the WP-500Select ON/OFF WP-500 Rear Panel Features Using Your WP-500 USB PortConnecting the WP-500 Front Panel Connecting the WP-500 Rear Panel Cond Dyn Configuration Setup Example Operating the WP-500Technical Specifications Technical Specifications 1 of the WP-500Limited Warranty 2900-000623 REV