Servicing Instructions Electrical, Risk of Injury

SERVICING INSTRUCTIONS - ELECTRICAL

WARNING:

RISK OF INJURY

The following servicing sections are for operator reference only. All servicing and/or repairs must be performed by a qualified technician

FILL
			WATER
	CONTROLLER		LEVEL
	CONTROLLER		PROBE
			FILL
			SOLENOID
HEAT
LINE	BREW
VOLTAGE	BREW		WATER
	TEMP		WATER
HI-LIMIT	TEMP		TEMP
HI-LIMIT			TEMP
T STAT	CONTROLLER		PROBE
TRIAC
HEATING
ELEMENT
BREW	BREW	DRIP OUT
	TIME	TIME
	CONTROLLER		BREW
			BREW
			SOLENOID
	BREW	BREW
	BREW	CANCEL
WARMER		QUALITY
		QUALITY
		TIME
	CONTROLLER		WARMER
	CONTROLLER		ELEMENT
			ELEMENT
		WARMER

Reset Hi-Limit Thermostat 240 V & Dual Voltage Units

FUNCTION

1.Pressing the POWER key energizes the unit. The POWER LED will glow whenever the unit is ON.

2.Automatic fill is accomplished via a FILL SOLENOID

(32)and a WATER LEVEL PROBE (7). The probe

senses ground through the water in the tank. When the water level falls below the probe and ground is no longer sensed, the CONTROLLER (20) energizes the fill solenoid (32) until the water level again reaches the water level probe.

3.Pressing the BREW key begins the brew cycle. Pressing the CANCEL key at any time during the

brew cycle terminates the brew. The BREW SOLENOID

(18)is energized by the CONTROLLER (20) for a time determined by the BREW TIME setting.

A second brew can be started only after the brew time plus the DRIP OUT time has elapsed.

4.Brew water temperature is controlled via a WATER TEMPERATURE SENSOR (3) and a HEATING ELEMENT (15) controlled by a TRIAC (17) electronic switch. The element is energized according to the sensed water temperature and the BREW TEMP setting.

An over-temperature condition will trip the HI-LIMIT THERMOSTAT (4), de-energizing the heating element. Note: On 120 volt units, hi-limit will automatically reset once the tank has cooled by approximately 30ºF. On 240 volt units and dual voltage units, the hi-limit must be manually reset by pressing the red button after the unit cools.

5.Individual WARMER PLATES (27) are heated by WARMER ELEMENTS (28), which are controlled by the WARMER keys. Pressing a warmer key will turn ON or OFF the corresponding warmer and LED.

MAIN WARMER PLATE is turned ON automatically at the start of a brew cycle.

Because coffee loses its freshness after sitting on a warmer, a quality time function is included. The WARMER LEDS will begin to flash some time after the last brew cycle, based on the QUALITY TIME setting. Note: QUALITY TIMER does not turn off the warmer elements.

6.The unit will revert to the energy-saver mode some time after the last brew, based on AFTER HOURS TIME setting.