AEG 80850 I Leak Prevention System, Electrical connection, Appliance is automatically pumped out

Page 42

Installation and Connection Instructions

 

Leak Prevention System

 

For protection from damage due to water leaks, the dishwasher is

 

equipped with a leak prevention system, the AQUA CONTROL SYSTEM.

 

In the event of a fault, the safety valve immediately interrupts the sup-

 

ply of water to the appliance and the drain pump switches on. It is thus

 

not possible for water to either leak or overflow. Any water left in the

 

appliance is automatically pumped out.

1

The AQUA CONTROL SYSTEM also works when the appliance is switched

 

off – the appliance must however not be disconnected from the mains.

When the appliance is switched on, a buzzing tone can also be heard.

Electrical connection

1

In compliance with electric company technical requirements for mains

 

connections, hard-wired connections to the mains may only be made

by approved electri-cians.

When connecting the appliance, observe the German VDE regulations and, if applicable, any additional conditions required by your local elec- tricity supplier. Following installation, live parts and live insulated wir- ing must not be accessible using a finger test in accordance with EN 60335/DIN VDE 0700.

Information on the electrical connection can be found on the rating plate on the right side of the inner edge of the dishwasher door. If the appliance has a change-over switch, the additional instructions on the change-over diagram in the mains connector box must be observed.

Prior to connecting ensure that the mains voltage and current rating at the site of installation match the nominal voltage and current rating given on the rating plate. The required fuse protection is also to be found on the rating plate.

To isolate the dishwasher from the mains, remove the mains plug. Important: The plug must still be accessible after the appliance has been installed.

If the appliance is hard-wired to the mains supply, then it must be safely isolated from the mains within the electrical installation with switches intended to ensure all-pole(N,L1)disconnection, shall be directly connected to the supply terminals and shall have a contact separation (fuses, cut outs, current trips or similar) of at least 3mm in each pole.

42

Page 41 Page 43
Image 42
Page 41 Page 43
Contents Ökofavorit 80850 Please read these user instructions carefully Tips on using the applianceDear customer Use of the appliance are marked with a clover leafContents Installation and Connection Instructions Safety Instructions Installation, Connection and Placing into OperationChild Safety General Safety Correct UseDisposal of old appliances DisposalDisposing of the Packaging Material POM For polyoxymethylene, e.g. plastic clipsEconomical and Ecological Dishwashing Appliance Features and Control Panel Control Panel Multi-Display can displaySpecial salt Prior to using for the first timeAdjusting the Water Softener Hardness range of the water in your areaUse special salt Open the door, remove the lower Rack Filling with Special Salt for the Water SoftenerFill with special salt Turning it anticlockwiseOperating Instructions Would damage the appliance Filling with Rinse AidThat you glasses are clear Fill with rinse aidAdjusting Rinse Aid Dosing Setting the Signal Tone for the End of the Wash Pro- grammeNot be washed in the dishwasher Daily UseLoading cutlery and dishes For washing in the dishwasher the following cutlery/dishesLoading Cutlery To avoid damage to glasses, they must not touchDo not lay small objects e.g. lids in the cutlery rack Both parts of the two part handle If you use the grid insert, it is notTo ensure that the cutlery basket Work surfaceLoading Pans, Frying Pans Large Plates Load large and heavily soiled dishes in the lower rackLoading Cups, Glasses and Coffee Services Lowering the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Type Raising the Upper BasketFilling with Detergent Fill with detergentBio Wash Programmes and Concentrated Detergents Automatic Wash ProgrammesSelecting the Wash Programme Programme Table Soiling SuitableSequence Starting the Wash Programme GrammeChanging the wash programme Setting the start delay timer Setting or Changing the Start Delay TimerCancelling the wash programme Pause FunctionLoad Sensing Sensor Logic Switching Off the DishwasherChanging the start delay Emptying the DishwasherCare and Cleaning Cleaning the FilterUnder no circumstances may Fault messages are displayed What to do, whenMalfunction Possible Cause Remedy Open the door carefully Dishes are still dirty There are problems with the operation of the dish- washerWash result is not satisfactory Wrong wash programme was selectedRinse aid was not used Rinse aid container is empty Drain hose is incorrectly laidDishes are wet and dull Decrease rinse aid dosingDishwasher Free-Standing Appliances Dishwashers that Can Be Integrated, Built-In DishwashersDishwashers that Can Be Fully Integrated Sample loading arrangements Upper basket without cutlery trayLower basket with cutlery basket Cutlery basket Installation and Connection Instructions Installing the DishwasherDishwashers That Can Be Integrated Built-In DishwasherFree-Standing Appliances Free-standing appliances can be Plinth on free-standing appliances is not adjustableWork surface must be re-mounted Fitted with a décor panel to matchPermitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseExtension hoses Water drainDrain hose Sink outlet connectionLeak Prevention System Electrical connectionAppliance is automatically pumped out Connections Australia Korea South Namibia E. Abu Dhabi Jordan MaltaEgypt Kanada Mauritius Croatia New ZealandHongkong Lthuania Russia Cyprus Lebanon OmanEstonia Latavia Poland Israel Malaysia Saudi ArabiaWeitere Kundendienststellen im Ausland Further after-sales service agencies overseasAutres agences étrangères assurant le service après-vente Otros puntos de Postventa en el extranjeroService AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG

80850 I specifications

The AEG 80850 I is an innovative and powerful kitchen appliance that brings efficiency and versatility to meal preparation. Designed with modern home cooks in mind, this induction hob stands out for its sleek design, user-friendly features, and advanced cooking technologies.

One of the main features of the AEG 80850 I is its induction cooking technology. Induction hobs use electromagnetic fields to directly heat the cookware, providing rapid heating and precise temperature control. This not only reduces cooking times but also enhances energy efficiency, as the heat is focused directly on the pan rather than the surrounding area. The result is a quicker and more economical cooking experience.

The AEG 80850 I offers a spacious cooking surface, accommodating multiple pots and pans simultaneously. With several cooking zones of varying sizes, users can easily tailor their cooking setup to suit different meals. The hob includes features like a large diameter zone for larger cookware, ensuring optimal use of the available space.

In addition, the AEG 80850 I features a boost function for each cooking zone. This allows for an intense burst of heat, ideal for boiling water quickly or searing meat at high temperatures. Once the desired temperature is reached, the hob automatically adjusts back to the selected cooking level, promoting convenience and preventing overcooking.

Safety is a priority with the AEG 80850 I. The appliance is equipped with features such as a child lock, ensuring that the hob cannot be accidentally turned on by young children. Moreover, the residual heat indicators provide a visual cue when a cooking zone is still hot, reducing the risk of burns.

The design of the AEG 80850 I is both modern and functional. The flat surface is easy to clean, as spills do not get trapped beneath burners. Its minimalist aesthetic makes it a stylish addition to any kitchen.

Moreover, the AEG 80850 I features a touch control panel for easy operation. Users can seamlessly adjust settings and temperatures with intuitive controls, allowing for a stress-free cooking experience.

Overall, the AEG 80850 I is a sophisticated induction hob that combines cutting-edge technology with stylish design and user-friendly features. Its rapid heating capability, safety features, and easy cleaning make it a must-have for any contemporary kitchen. Whether you are a novice cook or a seasoned chef, this induction hob is designed to enhance your cooking experience and deliver delicious results.
Top Page Image Contents