AEG 50730 manual Start the wash programme, Interrupting or ending the wash programme, Washer

Page 26

Operating Instructions

Start the wash programme

0 1. Check that when the dishes and cutlery are loaded in the dishwasher the spray arms are free to rotate.

2.Open the water tap fully.

3.Shut the door.

4.Press the ON/OFF button. ON/OFF button indicator comes on.

5.Press the button for the programme required (see “Programme Table“). The programme indicator lights up. One or two lights will flash in the multi-display. During this time it is possible to reselect the programme. The selected washing programme begins after approx. 6 seconds. The current wash programme stage will always be shown in the multi-dis- play.

3	If the top light and/or the middle light in the multi-display flash after
	the programme has started please read the section “What to do, if...“.
	Interrupting or ending the wash programme
3	Only interrupt a wash programme in progress if it is absolutely neces-
	sary. After the appliance door has been closed again the air that has
	entered will be quickly heated and expand. As a result water may pene-
	trate the base of the appliance and trigger the anti-flood system.
	Interrupting the wash programme by opening the door of the dish-
	washer
1	Hot steam can escape from the appliance when the door is opened.
	Open the door carefully.

0 1. Open the door of the dishwasher. The wash programme will stop.

2.Lights are flashing in the multi-display.

3.Shut the door. The wash programme will continue.

Ending the wash programme

0 1. Press the button for the wash programme that is running and hold it down until the programme indicator for the wash programme goes out.

2.Release the programme button; the wash programme has been ended.

26

Image 26

Contents Favorit Please read these user instructions carefully Tips on using the applianceDear customer Pass them on to any subsequent owner of the applianceContents Installation and Connection Instructions Child Safety Safety InstructionsInstallation, Connection and Placing into Operation General SafetyCorrect Use Disposing of the Packaging Material DisposalEconomical and Ecological Dishwashing Disposal of Old AppliancesAppliance Features and Control Panel Ning Which fault has occurred on the dishwasherControl panel Your area Prior to using for the first timeAdjust the water softener PanelElectronic setting Dishwasher must be switched offManual setting Ing the appropriate buttonRemain illuminated Open the door, remove the lower Basket Filling with Salt for the Water SoftenerFill with dishwasher salt Turning it anticlockwiseRinse aid can be added in one of two ways To switch off the control indicator for rinse aidRinse aid Filling with rinse aid Fully open the rinse aid compartment lidAdjusting Rinse Aid Dosing Not be washed in the dishwasher Daily UseLoading Cutlery and Dishes Loading Cutlery To ease the loading of large items Loading Pans, Frying Pans Large PlatesFolded over to the left Two right-hand plate insertsTwo rear plate inserts in the lower Folded across one anotherAcross one another Baskets can be folded across one anotherLoading Cups, Glasses and Coffee Services Raising the Upper Basket Adjusting the Height of the Upper BasketLowering the Upper Basket Filling with Detergent Fill with detergent Use of 3 in 1/ Combi Detergent Tablets General Advice Special Advice Concentrated Detergent Detergent tabletsSelecting the Wash Programme Programme Table SoilingWasher Start the wash programmeInterrupting or ending the wash programme Open the door carefullyChanging the delay start timer Setting or changing the delay start timerSetting the delay start timer Pause functionSive cleaners Care and CleaningSwitching Off the Dishwasher Emptying the DishwasherCleaning the Filter Fault warnings are displayed What to do, ifDishes are still dirty There are problems operating the dishwasherWash results are unsatisfactory Dishes are wet and dullThere are dried water drops on the glasses and dishes Technical DataDecrease rinse aid dosing Sample loading arrangements Upper basket Lower basket with cutlery basketBuilt-Under Dishwasher Installing the DishwasherSee enclosed installation instructions Free-Standing AppliancesPlinth on free-standing appliances is not adjustable Work surface must be re-mountedPermitted water pressure Connecting the DishwasherWater Connection Connect the inlet hoseWater inlet hose with safety valve Please take care when installing the water inlet hoseWater drain Leak Prevention System Appliance is automatically pumped outElectrical Connection Changing a fuseConnections Guarantee Conditions Calls may be recorded for training purposes 08705 929Customer Care AEG Hausgeräte GmbH Postfach 90327 Nürnberg Copyright by AEG