Ice pack
There is an ice pack in one drawer of the freezer.
In the event of a power failure or malfunction, the ice pack will lengthen the amount of time it takes for the frozen food to become too warm by several hours. The ice pack can only fulfil this task efficiently if it is placed in the uppermost drawer, at the front, above the frozen food. You can use the ice pack for cooling cold bags.
Preparation of Ice Cubes
1.Fill the ice cube tray 3/4 full with cold water, place it in the freezer com- partment and leave to freeze.
2.To loosen the frozen cubes, either twist the ice cube tray or hold it under running water for a few seconds.
Important! Never try to free an ice tray that is frozen to the freezer com- partment using pointed or sharp edged objects. Use the ice scraper supplied.
Storage Goods Symbols/Freezing Calendar
Installation Location
This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rat- ing plate, which is located on the inside left of the appliance.
The following table shows which ambient temperature is correct for each climate classification.
Climate classification |
| for an ambient temperature of |
|
|
|
|
|
|
SN |
| +10 to +32 °C |
|
|
|
N |
| +16 to +32 °C |
|
|
|
The appliance should be located in a dry atmosphere, out of direct sunlight and away from continuous heat and extreme temperature, e.g. not next to a boiler or radiator, or in a very cold room e.g. an outhouse. If these tem- peratures are exceeded i.e. warmer or colder, then the appliance may not operate correctly.
For
•The symbols on the drawers show different types of frozen goods.
•The numbers indicate storage times
in months for the appropriate types of frozen goods. Whether the upper or lower value of the indicated storage time is valid depends on the quality of the foods and
Your appliance needs air
For safety reasons, minimum ventila- tion must be as shown Fig.
Attention: keep ventilation openings clear of obstruction;
50 mm | min. |
200 cm2 | |
| min. |
| 200 cm2 |
D567 |
|
Reversing the door
The side the door opens can be changed from the right side (factory adjust- ment) to the left side, if the installation site requires.
Warning! When changing the side the door opens, the appliance must not be connected to the mains. Remove plug from the mains beforehand.
10 | 19 |