Symptom |
| Possible Cause |
| Remedy |
|
|
|
|
|
Changing the light bulb
Appliance is not switched on |
Mains plug is not plugged in |
or is loose. |
Switch on the appliance.
Insert mains plug.
Warning! There is a risk of electric shocks! Before changing the light bulb, switch off the appliance and unplug it. Light bulb data:
Appliance does not work. |
| ||
Fuse has blown or is defective. | |||
|
| ||
|
|
| |
|
|
| |
|
| Socket is defective. | |
|
|
| |
|
| ||
Appliance cools too much. |
| Temperature is set too cold. | |
|
|
| |
|
|
| |
|
| Temperature is not properly | |
|
| adjusted. | |
|
|
| |
|
| Door was open for an exten- | |
|
| ded period. | |
The food is too warm. |
| ||
A large quantity of warm food | |||
|
| was placed in the appliance | |
|
| within the last 24 hours. | |
|
| The appliance is near a heat | |
Check fuse, replace if neces- sary.
Mains malfunctions are to be corrected by an electrician. Turn the temperature control knob to a warmer setting.
Please look in the "Initial Start Up" section.
Open the door only as long as necessary.
Turn the temperature control knob to a colder setting.
Please look in the "Installation
1.To switch off the appliance, turn the temperature control knob to position "0".
2.Unplug the mains plug.
3.To change the light bulb, remove the screw from the light bulb cover.
4.Unhook the light bulb cover as shown.
5.Change the defective light bulb.
6.Refit the light bulb cover and the screw.
AEG65 |
source. |
Interior lighting does not work. Light bulb is defective.
location" section.
Please look in the "Changing the Light Bulb" section. Carefully warm the leaking sections of the door seal with a hair dryer (not hotter than
7.Put the refrigerator back into opera- tion.
Heavy build up of frost, possi- bly also on the door seal.
The compressor does not start immediately after changing the temperature setting. Water on the floor or on sto- rage shelves.
Door seal is not air tight (pos- sibly after reversing the door).
This is normal, no error has occurred.
Water drain hole is blocked.
approx. 50 °C). At the same time shape the warmed door seal by hand until it sits cor- rectly.
The compressor starts after a period of time.
See the "Cleaning and Care" section.
If, after carrying out the necessary checks there is still a fault with your appliance please contact your local AEG Service Force Centre.
In guarantee customers should ensure that the suggested checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown.
Please note that proof of purchase is required for any
14 | 15 |