Min mm 20 mm | AEG HK654200FB instruction

6Installation instructions

•Make electrical mains terminal free of voltage.

•Install correctly to give shock protection.

•Loose and incorrect plug and socket connections can make the terminal become too hot.

•A qualified electrician must install the connections in the clamps correctly.

•Use a strain relief clamp on cable.

•Use the correct mains cable of type H05BB-F Tmax 90°C (or higher) for a single phase or two phase connection.

•Replace the damaged mains cable with a special cable (type H05BB-F Tmax 90°C; or higher). Speak your local Service Centre.

The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm.

You must have correct devices to isolate: line protecting cut-outs, fuses (screw type fuses removed from the holder), earth leakage trips and contactors.

Assembly

	min.
	500mm
min.	min.
50mm	50mm
	min.
	5mm

R5mm

600mm

=	490+1mm 560+1mm
	=

min. 25 mm min.

min. 5 mm 20 mm

min. 38 mm

min. 5 mm