Bosch Appliances SHU43E, SHU6E, SHU53, SHV56A Drain Hose Connection, Sink with Air Gap/ No Disposer

DRAIN HOSE CONNECTION

THESE INSTALLATION

INSTRUCTIONS ARE

INTENDEDFORUSEBY

QUALIFIEDINSTALLERS

Be sure to follow your national and local codes at all times.

Drain Hose

•Before beginning, turn off the water supply!

•The access hole for the drain hose should be 1.25” (32 mm) diameter.

•Use the hose clamps and rubber connection hose (Figure 3) to connect the drain hose to the sink, disposer or air gap (Figure 14).

Openings for drain lines must be installed in the marked areas as shown in Figures 8 and 9 to avoid interference with the dishwasher frame or other components.

Drain Hose		Air Gap
in Sink with
Air Gap/ No
Disposer		Rubber
		Connector
min.20” (500 mm)	clearanceto floor	Trap
		Figure 12
		Air Gap
Drain Hose
in Sink
with Air
Gap &		Rubber
Disposer		Connector
min.20” (500 mm)	clearanceto floor	disposer

Trap

Figure 13

CAUTION

Failure to provide the proper drain connection height, 20” (508mm) above floor level with high loop or air gap, will result in improper draining of the dishwasher. Improper draining may cause damage to the dishwasher.

Drain Hose	G, Fig 3
Connected
to Sink

Figure 14

www.boschappliances.com ENGLISH - 9