Yamaha HTR-5940 AV Good No Good, Plug in the subwoofer to the AC outlet, Before connecting

CONNECTIONS

	U.S.A., Canada and Australia models only
Connecting to the INPUT1/OUTPUT
	Banana Plug conection are also possible.
terminals of the subwoofer
	1 Tighten the terminal knob.
For connection, keep the speaker cables as short as
	2 Simply insert the banana plug into the terminal.
possible. Do not bundle or roll up the excess part of the	￿	￿
cables. If the connections are faulty, no sound will be heard
from the subwoofer or the speakers, or both of them. Make
sure that the + and – polarity markings of the speaker
cables are observed and set correctly. If these cables are

reversed, the sound will be unnatural and lack bass.

Caution

Do not let the bare speaker wires touch each other, because this could damage the subwoofer or the amplifier, or both of them.

■Before connecting

Remove the insulation coating at the extremity of each speaker cable by twisting the coating off.

Good No Good

<YST-SW215>

1Press and hold the terminal’s tab, as shown in the figure.

2Insert the bare wire.

3Release your finger from the tab to allow it to lock securely on the cable’s wire end.

4Test the firmness of the connection by pulling lightly on the cable at the terminal.

Red:￿positive (+)	￿
Black: negative (–)

■How to connect:

<YST-SW315>

1 Loosen the terminal’s knob, as shown in the figure. 2 Insert the bare wire.

3 Tighten the knob.

4 Test the firmness of the connection by pulling lightly on the cable at the terminal.

Red: positive (+)	Plug in the subwoofer to the AC outlet
Black: negative (–)
	After all connections are completed, plug in the subwoofer
	and other audio/video components to the AC outlet.
	<YST-SW315>

To AC outlet

<YST-SW215>

To AC outlet

12