Connecting Devices to the SGE2010/SGE2010P
Connecting the Cables
Wall-Mount Placement
1.On one of the side corners, remove the four front screws on of the Ethernet switch. Retain the screws for
NOTE: The Ethernet switch, shown below, is mounted with the ports located on top. When the switch is mounted to a wall, the ports can be oriented in any direction.
2.Place one of the supplied spacers on the side of the Ethernet switch so the four holes align to the screw holes.
3.Place a rack mount bracket next to the spacer and reinstall the four screws (removed in step 1). The wall mount brackets should point towards the bottom of the Ethernet switch.
4.Repeat steps 1 through 3 for the other corners of the Ethernet switch.
5.Attach the Ethernet switch to a wall with appropriate screws (not supplied). CAUTION: Ensure that the Ethernet switch is securely attached to the wall.
Connecting the Cables
To connect network devices to the Ethernet switch, follow these instructions:
1.For 10/100Mbps devices, connect a Category 5 Ethernet network cable to one of the numbered ports on the Ethernet switch. For a 1000Mbps device, connect a Category 5e Ethernet network cable to one of the uplink ports on the Ethernet switch.
NOTE: If connecting an Ethernet switch to an SVR3000 router, connect it to a Cascade port on the SVR3000.
2.Connect the other end to a PC or other network device.
3.Repeat steps 2 and 3 to connect additional devices.
4.If you are using the
SGE2010/SGE2010P Administration Guide | 7 |
