IPv6 Address Table | Linksys SGE2010P guide

Using the Console

System Configuration

IPv6 Address Table

The IPv6 Address Table lists the IPv6 addresses that are configured.

To open this screen:

1.From the Switch Main Menu, select 1. System Configuration.

2.From the System Configuration Menu, select 6. IP Configuration.

3.From the IP Configuration menu, select 2. IPv6 Address Configuration.

4.From the IPv6 Address Configuration menu, select 3. IPv6 Address Table.

IPv6 ISATAP Enable

You can use the IPv6 ISATAP Enable screen to configure the ISATAP tunnel.

To open this screen:

1.From the Switch Main Menu, select 1. System Configuration.

2.From the System Configuration Menu, select 6. IP Configuration.

3.From the IP Configuration menu, select 2. IPv6 Address Configuration.

4.From the IPv6 Address Configuration menu, select 4. IPv6 ISATAP Enable.

SGE2010/SGE2010P Administration Guide

31

Image 34

Linksys SGE2010P manual IPv6 Address Table

Contents

Port 10/100/1000 Ethernet Switch Table of Contents Contacts Introduction What’s in this User Guide? Getting to Know the SGE2010/SGE2010P SGE2010/P Front Panel Getting to Know the SGE2010/SGE2010P SGE2010/P Back Panel Sample Network Configuration Maximum Cabling Distances Placement Options Before You Install the SwitchDesktop Placement Rack-Mount Placement Connecting the Cables Wall-Mount Placement Connecting Devices to the SGE2010/SGE2010P Using the Console Connecting to Your Switch with HyperTerminal Using the Console Set the serial port settings as follows Logging On to the Console Connecting to the Switch with TelnetSelecting Menu Options and Actions Using the Switch Main Menu System Configuration To open this screen System InformationTo open this menu Versions General Information Management Settings To change the system contact, system name, and location Telnet Configuration Serial Port ConfigurationTo change the baud rate of the serial port SSH Configuration To change the time-out setting SSH Server Configuration To change SSH Server settings To change SSH Crypto Key Generation settings Username & Password Settings To generate the crypto key Security Settings To change User & Password settings SSL Generate Certificate To edit and execute a certificate To disable the active management access profile Disable Active Management Access ProfileShow Certificate Default Vlan Setup Vlan Management IP Configuration To edit the Vlan ID IPv4 Address Configuration To edit the IPv4 address settings IPv6 Address ConfigurationTo renew Dhcp To edit the IPv6 interface settings To edit the IPv6 address settings IPv6 Address Table To edit the Isatap tunnel settings IPv6 Default Gateway To edit the IPv6 default gateway settings To change the Http settings Http ConfigurationHttps Configuration To open the screen Network Configuration To change Https settings To change the IP address To begin the ping test Ping IPv6 To begin the trace route test TraceRoute IPv6 Upgrade / Backup IPv4 File Management To enter the IPv6 Upgrade/Backup file name and location Upgrade / Backup IPv6To enter the IPv4 Upgrade/Backup file name and location To download a file from the specified location To enter the active image settings Active Image Reboot System Restore System Default SettingsReset to Factory Settings To restore system default settings Stack Configuration Port Status Port Status PoE Status Port Configuration Port Settings PoE Settings To configure the ports System Mode Layer 2 / Layer 3 Selection To configure the PoE settings To edit the system mode or stacking mode Help Logout Connecting to the Switch with the Web-Based Utility Using Menus in the Web-Based Utility Viewing On-line Help US/Canada Contacts EU Contacts Customer Site Survey Yes Limited Warranty Exclusions and Limitations Obtaining Warranty Service Technical Support Obtaining Warranty Service Industry Canada Statement EC Declaration of Conformity Europe Specifications Radius Vlan EMC 080312A-LB