Rack-Mount Placement | Linksys SGE2010P guide

Connecting Devices to the SGE2010/SGE2010P

Placement Options

CAUTION: Keep enough ventilation space for the Ethernet switch so it does not exceed the environmental restrictions mentioned in the specifications.

Rack-Mount Placement

To mount the Ethernet switch in any standard-sized, 19-inch wide, (each Ethernet switch requires 1RU of space in the rack), follow these instructions:

1.Remove the four front screws on one side of the Ethernet switch. Retain the screws for re- installation.

2.Place one of the supplied spacers on the side of the Ethernet switch so the four holes align to the screw holes.

3.Place a rack mount bracket next to the spacer and reinstall the four screws (removed in step 1).

4.Repeat steps 2 through 3 for the other side of the Ethernet switch.

5.Attach the Ethernet switch to the rack using the supplied screws.

SGE2010/SGE2010P Administration Guide

6

Image 9

Linksys SGE2010P manual Rack-Mount Placement

Contents

Port 10/100/1000 Ethernet Switch Table of Contents Contacts What’s in this User Guide? Introduction SGE2010/P Front Panel Getting to Know the SGE2010/SGE2010P SGE2010/P Back Panel Getting to Know the SGE2010/SGE2010P Maximum Cabling Distances Sample Network Configuration Before You Install the Switch Placement OptionsDesktop Placement Rack-Mount Placement Wall-Mount Placement Connecting the Cables Connecting Devices to the SGE2010/SGE2010P Connecting to Your Switch with HyperTerminal Using the Console Using the Console Set the serial port settings as follows Connecting to the Switch with Telnet Logging On to the ConsoleSelecting Menu Options and Actions System Configuration Using the Switch Main Menu System Information To open this screenTo open this menu General Information Versions To change the system contact, system name, and location Management Settings Serial Port Configuration Telnet ConfigurationTo change the baud rate of the serial port To change the time-out setting SSH Configuration To change SSH Server settings SSH Server Configuration To change SSH Crypto Key Generation settings To generate the crypto key Username & Password Settings To change User & Password settings Security Settings To edit and execute a certificate SSL Generate Certificate Disable Active Management Access Profile To disable the active management access profileShow Certificate Vlan Management Default Vlan Setup To edit the Vlan ID IP Configuration IPv4 Address Configuration IPv6 Address Configuration To edit the IPv4 address settingsTo renew Dhcp To edit the IPv6 interface settings To edit the IPv6 address settings IPv6 Address Table To edit the Isatap tunnel settings To edit the IPv6 default gateway settings IPv6 Default Gateway Https Configuration Http ConfigurationTo change the Http settings To open the screen To change Https settings Network Configuration To begin the ping test To change the IP address Ping IPv6 To begin the trace route test TraceRoute IPv6 File Management Upgrade / Backup IPv4 To enter the IPv4 Upgrade/Backup file name and location Upgrade / Backup IPv6To enter the IPv6 Upgrade/Backup file name and location To download a file from the specified location Active Image To enter the active image settings Reset to Factory Settings Restore System Default SettingsReboot System To restore system default settings Port Status Stack Configuration PoE Status Port Status Port Settings Port Configuration To configure the ports PoE Settings To configure the PoE settings System Mode Layer 2 / Layer 3 Selection Help To edit the system mode or stacking mode Logout Using Menus in the Web-Based Utility Connecting to the Switch with the Web-Based Utility Viewing On-line Help EU Contacts US/Canada Contacts Customer Site Survey Yes Exclusions and Limitations Limited Warranty Obtaining Warranty Service Obtaining Warranty Service Technical Support EC Declaration of Conformity Europe Industry Canada Statement Specifications Radius Vlan EMC 080312A-LB