Linksys SGE2010, SGE2010P - page 41

SGE2010/SGE2010P Administ ration Guide 38
System Configuration
Using the Console
Trace Rout e IP v4
You can use the TraceRo ute I Pv4 screen to run a trace route test for an IPv4 address
To open the screen:
1. From the Switch Main Menu, select 1. System Configuration.
2. From the System Configuration Menu, select 6. IP Configuration.
3. From the IP Configuration menu, select 5. Network Configuration.
4. From the Network Configuration menu, select 3. Trace Router IPv4.
To change the IP address:
1. Select Edit, and then enter the IPv4 address.
2. Press the Esc key to move the cursor to the Action list.
To begin the trace route test:
1. Select Execute to begin the test.
2. After the test is complete, the results of the test appear on the screen.
3. When the Operation complete message appears, press the Esc key to move the cursor to the
Action list.