Logout | Linksys SGE2010P specs

Using the Console

Logout

Logout

The Logout command lets you logout from the Ethernet switch.

NOTE: When you issue this command, you are immediately logged off the Ethernet switch.

SGE2010/SGE2010P Administration Guide

50

Image 53

Linksys SGE2010P manual Logout

Contents

Port 10/100/1000 Ethernet Switch Table of Contents Contacts What’s in this User Guide? Introduction SGE2010/P Front Panel Getting to Know the SGE2010/SGE2010P SGE2010/P Back Panel Getting to Know the SGE2010/SGE2010P Maximum Cabling Distances Sample Network Configuration Desktop Placement Before You Install the SwitchPlacement Options Rack-Mount Placement Wall-Mount Placement Connecting the Cables Connecting Devices to the SGE2010/SGE2010P Connecting to Your Switch with HyperTerminal Using the Console Using the Console Set the serial port settings as follows Selecting Menu Options and Actions Connecting to the Switch with TelnetLogging On to the Console System Configuration Using the Switch Main Menu To open this menu System InformationTo open this screen General Information Versions To change the system contact, system name, and location Management Settings To change the baud rate of the serial port Serial Port ConfigurationTelnet Configuration To change the time-out setting SSH Configuration To change SSH Server settings SSH Server Configuration To change SSH Crypto Key Generation settings To generate the crypto key Username & Password Settings To change User & Password settings Security Settings To edit and execute a certificate SSL Generate Certificate Show Certificate Disable Active Management Access ProfileTo disable the active management access profile Vlan Management Default Vlan Setup To edit the Vlan ID IP Configuration IPv4 Address Configuration To renew Dhcp IPv6 Address ConfigurationTo edit the IPv4 address settings To edit the IPv6 interface settings To edit the IPv6 address settings IPv6 Address Table To edit the Isatap tunnel settings To edit the IPv6 default gateway settings IPv6 Default Gateway Https Configuration Http ConfigurationTo change the Http settings To open the screen To change Https settings Network Configuration To begin the ping test To change the IP address Ping IPv6 To begin the trace route test TraceRoute IPv6 File Management Upgrade / Backup IPv4 To enter the IPv4 Upgrade/Backup file name and location Upgrade / Backup IPv6To enter the IPv6 Upgrade/Backup file name and location To download a file from the specified location Active Image To enter the active image settings Reset to Factory Settings Restore System Default SettingsReboot System To restore system default settings Port Status Stack Configuration PoE Status Port Status Port Settings Port Configuration To configure the ports PoE Settings To configure the PoE settings System Mode Layer 2 / Layer 3 Selection Help To edit the system mode or stacking mode Logout Using Menus in the Web-Based Utility Connecting to the Switch with the Web-Based Utility Viewing On-line Help EU Contacts US/Canada Contacts Customer Site Survey Yes Exclusions and Limitations Limited Warranty Obtaining Warranty Service Obtaining Warranty Service Technical Support EC Declaration of Conformity Europe Industry Canada Statement Specifications Radius Vlan EMC 080312A-LB