Crosscut Fence |
|
Components and Hardware Needed: | Qty |
Crosscut Fence | 1 |
Center Stud | 1 |
Fiber Washer 8mm | 1 |
1 | |
Knob | 1 |
Knob | 1 |
1 | |
Flat Washer 8mm | 1 |
Tools Needed: | Qty |
Hex Wrench 6mm | 1 |
To install the crosscut fence: |
|
1.Thread the center stud and the fiber washer into the remaining
2.Slide the center stud, an
Knob
Center Stud |
| |
|
|
|
Figure 36. Crosscut fence assembly.
3.Slide the center stud to the end with the plas- tic cap and tighten it in place.
4.Insert the center stud and the T-bolt in the places indicated in Figure 37.
Center Stud
Placement
T-Bolt
Placement
Figure 37. Crosscut fence placement.
5.Secure the crosscut fence with the M8-1.25 knob with an 8mm flat washer threaded onto the T-bolt.
6.Unlock the crosscut fence extension and slide the flip stops into the fence as shown in Figure 38.
Figure 38. Stop block installation.
G0451 14" Sliding Table Saw |