Grizzly G0451 Extension Tables, Components and Hardware Needed Qty, Tools Needed Qty

Extension Tables

Components and Hardware Needed:	Qty
Large Extension Table	1
Small Extension Table	1
Support Brace	1
Dust Collection Hose Support	1
Cap Screws M10-1.5 x 30	4
Cap Screws M10-1.5 x 20	6
Hex Nuts M10-1.5	2
Lock Washers 10mm	10
Flat Washers 10mm	6
Set Screws M6-1 x 12	6
Tools Needed:	Qty
An Assistant	1
Hex Wrench 3mm	1
Hex Wrench 8mm	1
Socket or Wrench 16mm	1
Straightedge 4' (or longer)	1
To install the extension tables:

1.Thread the set screws into the small holes in both extension tables. Make sure the set screws do not stick out from the mating sur- face.

Note—Do not completely tighten the bolts in the following steps until the tables are leveled.

2.Attach the small extension table with two M10-1.5 x 20 cap screws, lock washers, and flat washers as shown in Figure 20. Note—Get assistance positioning the tables and holding them in place while installing.

Figure 20. Small extension table attachment. -22-

3.Attach the large extension table with four M10-1.5 x 20 cap screws, lock washers, and flat washers as shown in Figure 21.

Figure 21. Large extension table attachment.

4.Attach the support brace (Figure 22) to the table with two M10-1.5 x 30 cap screws and lock washers. Note—Do not attach the brace to the extension table until the next step.

Dust Collection

Hose Support

Support Brace

Figure 22. Support brace and dust collection

hose support installation.

5.Place the dust collection hose support over the support brace as shown in Figure 22 and thread M10-1.5 x 30 cap screws with lock washers through the remaining support brace holes and secure with hex nuts.

G0451 14" Sliding Table Saw